Removal & Installation - Starter
To install:
Negative battery cable
Radiator air baffle assembly
Electrical connections
Torque converter cover
Starter
Starter. Torque the bolts to 35 ft. lbs. (47 Nm).
Torque converter cover
Solenoid -BAT- terminal. Torque the nut to 89 inch lbs. (10 Nm).
Solenoid -S- terminal. Torque the nut to 27 inch lbs. (3 Nm).
Radiator air baffle assembly
Negative battery cable
Fig. Showing the starter motor location and electrical connections
To install:
Negative battery cable
Radiator air baffle, for clearance if necessary
Flywheel inspection cover bolts
Flywheel inspection cover
Electrical connections from the starter motor
Starter motor mounting bolts
Starter motor
NOTE
Before installing the starter motor to the engine, tighten the nut
next to the cap on the solenoid BAT terminal. If this terminal is not
tight in the solenoid cap, the cap may be damaged during installation of
electrical connections and cause the starter motor to fail later.
Starter motor
Starter motor mounting bolts and tighten the bolts to 30 ft. lbs. (40 Nm)
Electrical connection to the battery terminal on the solenoid and tighten the battery terminal nut to 13 ft. lbs. (17 Nm)
Electrical connections to the S terminal on the solenoid and tighten solenoid S terminal nut to 27 inch lbs. (3 Nm)
Flywheel inspection cover
Flywheel inspection cover bolts
Radiator air baffle, if removed
Hope helps, remember rated this.
FIRST YOU TURN OFF RADIO.THEN REMOVE NEGATIVE BATTERY CABLE.REMOVE THE RADIATOR AIR BAFFLE ASSEMBLY.REMOVE THE ELECTRICAL CONNECTIONS.REMOVE TORQUE CONVERTER COVER.THEN REMOVE STARTER.PUT EVERYTHING BACK VISA VERSA.TORQUE STARTER BOLTS 35 FT LBS.
1,350 views
Usually answered in minutes!
×