The leak at the electrical plug.. can you tell if its coming from around the edge(s).. or coming through the wires them selves(around the wires)..If you just want the leak to stop, you could remove the plug and replace the o-ring or what ever type seal is there... If its coming through the wire area (wires themselves),, you can use some devcon 2 ton epoxy..(clear and liquid you mix)
DEVCON 2 TON EPOXY 84fl oz SYRINGE Walmart com
.. about the length of the dipstick..not sure.. a "junk yard" may have one cheap...
SOURCE: honda accord 1996 starts, wont run
you blew your tranny from over heating it just because you have fluid doesnt meen that everything is fine your filter could have cloged not allowing proper fluid to the gears
SOURCE: need manual for chevy s10 blazer 1991 4wd. My
Why not use a test light and check all of them. each fuse has a small opening on the end facing you when installed.You can probe each fuse without even removing it.Ground the test light, turn the key to on and test away!!! check each end of each fuse. The light should light on both ends...the one that dosen't is bad. A headlight fuse won't always light on either end unless lights are turned on.It takes about ten minutes to check them all...Quicker and easier than poring over a manual!!!
SOURCE: dipstick tube leaking
cheek to make sure its not over full also the trans lines r right there make sure it not them spayin over after all u just did the motor and the trans was most likly hangin
SOURCE: how do you remove the front driveshaft on a 98
Remove the bolts from the ujoint going to the front differential, then remove the ones holding it to the transfer case comes out one end at a time.drop one side first then slide it out, reverse for install
171 views
Usually answered in minutes!
×