Sorry but their are no diadnostic codes with this number in the manufacturers codes i have
P0505....Idle Control System
P0507....Idle Control System RPM Higher Than Expected
but i have found these generic codes for you if they help
do the obvious and check for fuel and a spark first as i cannot see how a idler valve will stop engine from starting ,i would expect it not to idle not cut out completly
×
Change crank position sensor and blown ecm 15amp fuse
THIS IS FOR A 2.0 ENGINE SAME CODE DEFINITIONS APPLY FOR 2.7 ENGINE VALVE LOCATED ON TOP REAR OF RIGHT HEAD
P1505 = IDLE SIR CONTROLL CLOSING COIL-SIGNAL LOW FOR COIL #1 SHORTED TO POWER
P1507= IDLE AIR CONTROLL CLOSING COIL SIGNAL LOW FOR COIL #2 SHORTED TO POWER
UNPLUG IDLE AIR CONTROLL (3 WIRE TERMINAL ON INTAKE )
CHECK COIL RESISTANCE BETWEEN TERMINALS 2 & 3 SPEC IS 17 - 18 OHMS
FOR 2.0 ENGINE
WIRING TERMINAL LOCATION LOOKING INTO VEHICLE HARNESS AT VALVE SIDE OF CONNECTOR
2--3--1
2= ORG 12 VOLTS KEY ON
3=GREEN/BLACK SIGNAL FROM ECM CLOSING CIRCUIT
1= BLUE/WHITE SIGNAL FROM ECM OPENING CIRCUIT
FOR 2.7 ENGINE
LOOKING INTO VALVE SIDE OF CONNECTOR
3--1--2
3= BROWN ECM CLOSE
1= BLUE/RED ECM OPEN
2= ORANGE 12 VOLTS
HOPETHIS HELPS
4,463 views
Usually answered in minutes!
its was actually built july 2002 codes are p1505 and p1507 ran took it up road 3 minute ride pulled back in yard quite when down shifted into 1st gear no fire hear fuel pump
how to fix a code p0507 on a subaru empreza 2001
×