I need to know where the flasher is for the turn signals on a 1989 Ford Mustang 5.0. I found the one for the hazard lights.

Turn signals and flashers not working - MyTractorForum.com - The ...

www.mytractorforum.com/.../193023-turn-signals-flashers-not-working....

Jun 5, 2011 - My turn signals and flashers are not working on my BX1500. I can hear the ... I hear nothing when I depress the hazard button and no light.

Turn Signal and Flasher Repair JD4300 Recovered Part 7 ...

? 19:17
https://www.youtube.com/watch?v=UrLN5xzbOzY
May 9, 2014 - Uploaded by mars1952
Turn Signal and Flasher Repair JD4300 Recovered Part 7 ... I bought a 4310 new in 2004 and I know these are great tractors, not the ... I have a John Deere 4400 and I wouldn't mind putting a set of those on it to protect the lights. .... Ford Explorer 2003 - MyTurn Signals Stopped Working - Duration: 2:15.

That would depend on your model make and year of vech. Also depending on vech., most vech's. use the same flasher for t signals and flashers. To hazard a guess, you may have a bad t. switch or wiring problem.

the turn signal flasher is bad. it looks like the hazard flasher and only works the signals.

Yes they have separate flash turn signal also have a relay

you could try replacing the turn signal switch. they go out after awhile.

this sounds like the signal flasher is no good and needs replacing.its located under the dash to the left of the steering colume,put the hazard lights on and look under the dash and locate it.the signal flasher looks the same but is a different flasher and should be in the same area.

The electronic flasher is right next and part of the under dash fuse panel. The flasher looks like a fuelpump relay and may even plug where one goes, It has 5 blades, and costs 20 bucks at Oriley Auto parts/ This part seldom fails and it's designednot to blink but just stay on if there's a bulb out. Best check all of the bulbs by turning all the lights on with the hazard flasher sitch and see which ones aren't working and fix them first. If the hazards out the turns will too as the flasher is good anyway.

The hazard switch , turn signal switch , wiper switch are useually all one piece, Called a combo switch, They are known for going bad

If the signals come on, but don't flash, check & or replace your flasher, or swap it with hazard flasher if it's the same to confirm flasher is the problem. Hazard & blinkers are on serarate flashers.

The flasher is a small round plastic cylinder (unless replaced with a metal one) behind the left edge of the glove box that will look similar to the one in the fuse panel. The first step is to squeeze gently both sides of the open glove box and let it swing downward. It will be snapped into a metal horizontal brace just to the left of the glovebox opening by a small tab and have two wires attached. The number more than likely will be a #552 although I have seen a factory one with a Warner #224