This is for the 5 cylinder 3.5 liter engine in the Colorado
1. The drain plug is in the middle of the oil pan on the drivers side.
Use a 15 mm socket or box end wrench to remove the plug. Drain
oil.
2. The oil filter is at the bottom front corner of the engine on the passenger side. Remove the filter. Try not to tip the filter when you
remove it so you don't get oil on other parts of the truck.
3. Rub a small of oil on the gasket of the new filter. Spin on the new filter, 3/4 to 1 turn past when the gasket starts to seat. Hand tighten
only.
4. Reinstall the drain plug. DO NOT OVER TIGHTEN OR YOU COULD
STRIP THE THREADS.
5. Add 6 quarts of oil to the oil filler tube located on top of the engine
in the front and middle of the engine compartment. It shows the location
in the owners manual. Install the filler cap.
6. Start the engine and let it run a few minutes to fill the filter with oil.
Turn off the engine and wait a few minutes for the oil to drain down to
the bottom of the engine. Remove the dip stick and check oil level.
Checking oil level is in the owners manual.
SOURCE: How do I reset the "Oil Change Warning Indication" on colorado
if you have a owners manual read it. try coloradofans.com website and search the forums. i think johnny5846 is right if you don't have a DIC (driver info center). i believe you use the DIC(tripodometer). i don't know the sequence off hand, you can also you can change your lock settings and alarm settings, etc. with the DIC.
SOURCE: change the time on the base radio
On the right lower of the radio there are 2 arrow buttons. one changes the hour and the other changes the minute.
SOURCE: how do i change out the knock sensor on a 2006 chevy colorado
You didn't list your engine size so please pick the applicable to your motor size:
Removal & Installation
2.8L & 2.9L Engines
To Remove:
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)
To Install:
SOURCE: reset change oil light 2007 chevy colorado
Turn the key to the on position a then press the gas pedal three times within 5 seconds,the oil life light should flash 5 times then go out,then the oil life will be reset[the reset procedure is in the owners manual if this doesn't work].
931 views
Usually answered in minutes!
×