Audi a4 2-4 how do i turn out the service interval indicator

Possibly reset issue.
Google "D3 service interval reset" for instructions.
It is probably through the menu system.

Service interval mileage is also selectable on A8's through the menu system. I very much doubt anyone has altered this.

Okay... (looking at the fuel pump & clutch issues)
So you have had this car a while...

I left this sit hoping some one else would address your
ISSUE...

>> Assuming you have actually done the "SERVICE"

Watch the following video... (fast & easy)

How to reset service interval in Audi A2 A3 A4 A6 TT SRI SRL 2000 and newer

Carnac the Magnificent

Looks like you want to reset the service interval indicator. Either Google the question or read your owners manual.

You can't, you need to take it to your Audi garage as the diagnostic computer needs to be connected. On older models there were ways related to the sequence of using various ignition settings, indicator presses etc.. not anyy more

1-Turn off the ignition.
2-Place the reset tool into the diagnostic system, found near the Audi's hood release latch.
3-Press the reset tool's "Select" button.
4-Turn on the ignition, but do not start the engine.
5-Press the "Enter" button on the tool and wait 10 seconds for the tool's lights to come on.
6-Turn off the ignition. Remove the reset tool from the Audi Q7

Audi Q5 - MY 2010
The Service Interval Indicator can only be reset with the VAS 5051 or similar diagnostic tool connected to the data link connector of the car.

Audi Q7 4.2 FSI - MY 2007
The Service Interval Indicator can only be reset with the VAS 5051 or similar diagnostic tool connected to the data link connector of the car.

Audi A8 - MY 2006
The Service Interval Indicator can only be reset with the VAS 5051 or similar diagnostic tool connected to the data link connector of the car.

Audi Q7 3.0 TDI - MY 2009
The Service Interval Indicator can only be reset with the VAS 5051 or similar diagnostic tool connected to the data link connector of the car.

NOTE: If the service interval indicator flashes it may be caused by one of the service interval indicator parameters not being programmed. This can only be done with suitable diagnostic equipment. Always check for any stored trouble codes as this may affect the resetting of the service interval indicator.
Turn ignition key to position I. Press and hold reset button [A] 20573 for trip meter. Turn ignition key to position II. Keep button [A] depressed until service interval indicator flashes (approximately 10 seconds). Release reset button [A] within 5 seconds. There will be an audible signal when reset complete. If reset button is not released within 5 seconds, the service interval indicator will not be reset but will stop flashing.

Vehicles on longlife service intervals must have the service interval indicator reset using suitable diagnostic equipment. Vehicles on fixed interval servicing can be reset as follows: Press and hold button [A] 84764. Switch ignition ON. The words "SERVICE" or "SERVICE IN xxxx MI" will appear in the trip recorder display. Release button [A]. Press button [B] to reset the display. The words "SERVICE IN 10 000 MI" will appear in the trip recorder display. Switch ignition OFF.
BUTTON A IS LEFT OFF SPEEDO
BUTTON B IS RIGHT OFF REV COUNTER