SOURCE: 1996 ford escourt overheating. changed waterpump
You have combustion gases getting into the cooling system, that much is sure, if u didn't have the headed for poss warp-age then a new head gasket will leak, these heads warp really bad, we always have them trued up or we won't guarantee the job.
SOURCE: Oil light flashing, last oil change 7 wks ago
I belive they didn't reset the oil light timer. I belive the sequence is 1. key on (not acc with engine off)
2. step on the brake pedal 5 times within 10 seconds. 3. key off. 4. start car. 5. check if the light went out. you may have to try it a few times to get it.
SOURCE: I have a 2001 jeep grand cherokee losing antifreeze no leaks.
good point there is a good chance this has a cracked head
SOURCE: remove/replace radiator--1997 pontiac grand am
REMOVAL & INSTALLATION
CAUTION
Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.
A cross-flow radiator is used on most models. The radiators used on automatic transaxle models are equipped with oil coolers with inlet and outlet fittings for transmission fluid circulation. An aluminum-plastic radiator can be identified by the black plastic side tanks and aluminum radiator.
To install:
If the engine cooling fan was removed while the vehicle was in the air, install the assembly and attach all electrical wiring.
126 views
Usually answered in minutes!
×