My escort has no go power like its getting no gas

Try a fuel filter:
Fuel Filter REMOVAL & INSTALLATION The in-line fuel filter is located in the engine compartment between the fuel tank and the fuel rail.

1. Properly relieve the fuel system pressure.
2. Disconnect the negative battery cable.
3. Position a suitable container below the fuel filter to collect any excess fuel that may leak from the filter and lines. CAUTION
   Observe all applicable safety precautions when working around fuel. Whenever servicing the fuel system, always work in a well ventilated area. Do not allow fuel spray or vapors to come in contact with a spark or open flame. Keep a dry chemical fire extinguisher near the work area. Always keep fuel in a container specifically designed for fuel storage; also, always properly seal fuel containers to avoid the possibility of fire or explosion.
   
4. Remove the retaining clip from the fuel filter upper hose.
5. Disconnect the upper hose from the fuel filter and drain any excess fuel into the container. Plug the hose.
6. Raise and safely support the vehicle.
7. Remove the retaining clip from the fuel filter lower hose.
8. Disconnect the lower hose from the fuel filter and drain any excess fuel into the container. Plug the hose.
9. Lower the vehicle.
10. Unfasten the filter retaining clamp screw and remove the fuel filter. Fig. 1: The fuel filter is located in the engine compartment, between the fuel tank and fuel rail — 1.9L engine's underside shown
    Fig. 2: To remove the fuel filter upper hose clip, grasp the clip (arrow) . . .
    Fig. 3: . . . and gently pull the clip from the hose. (Lower hose clip removal is similar)
    Fig. 4: Grasp the hose and pull it fmy escort has no go - 90981p50.jpg filter
    Fig. 5: my escort has no go - 90981p51.jpg filter retaining clamp screw
    
    To install:
    
11. Position the fuel filter and tighten the filter mounting clamp.
12. Remove the plug, then connect the upper hose to the filter and install the hose retaining clip.
13. Raise and safely support the vehicle.
14. Remove the plug, connect the lower hose to the filter and install the hose retaining clip.
15. Lower the vehicle.
16. Connect the negative battery cable.
17. Start the engine and check for leaks.