How do I replace side view mirrors on a 05 Acura TL

ck here....

https://duckduckgo.com/?t=ffab&q=+remove+the+wiring+from+the+rear+view+mirror+in+a+04+Acura+TL&atb=v159-1&ia=web

Question edited. although people say 'oh-5' is actually '2 zero, zero, five.

Here is your fuse box diagram, there are a few that cover seats, but as your issue is seat memory and mirrors, I think you have a Body Control Module communication issue, so you need a good auto-electrician, with a pro grade scan tool computer.

https://fuse-box.info/acura/acura-tl-ua6-ua7-2004-2008-fuses

..

there is a super glue made by loctite products that is especially for glass
it is used by manufacturers to stick the base of the rear view mirror to the glass

Replacing the rear view mirror has nothing to do with a non starting issue. Just a coincidence unless your rear view mirror was in the engine compartment and you tore everything apart to replace it.

Meanwhile check for spark and fuel flow to engine. One of those areas including fuses will hold the key to your dilemma. Do not overlook igniter(s) and crankcase sensor in electrical system.

you can not replace just the glass. you need to replace the whole mirror. sorry

here's 1996, all I have. Please rate.

Mirror, Power — Outside Rear View NOTE: This procedure applies to both RH and LH power outside rear view mirrors.

Removal

1. Remove the front door trim panel (23942). Refer to Section 01-05 for the removal procedure.
   

1. Remove the two outside rear view mirror inside mounting hole cover screws and the outside rear view mirror mounting hole cover (17K709) from the front door (20124).
   
   
   
   
   

1. Remove the wire clip.
   

1. Disconnect the power outside rear view mirror electrical connector.
   
   
   
   
   

1. Remove the three power outside rear view mirror bolts and the power outside rear view mirror.
   
   
   
   
   

Installation
To install, reverse the removal procedure. Tighten the three power outside rear view mirror bolts to 3-4 Nm (27-35 lb-in). Glass, Outside Mirror
Removal and Installation
Refer to the glass replacement procedures in Manual Mirror for power outside rear view mirror glass (17K707) Trim Cover
Removal

1. Remove the front door trim panel. Refer to Section 01-05 for the removal procedure.
   

1. Remove the two outside rear view mirror inside mounting hole cover screws.
   
   
   Remove the outside rear view mirror mounting hole cover.

Installation
To install, reverse the removal procedure. Mirror Control
Removal

1. Use a small flat-blade screwdriver to pry the power outside rear view mirror control switch from the instrument panel (04320).
   
   
   

is it just the glass that broke?

Exterior Mirror Glass Removal

1. Position the inner edge or the exterior rear view mirror glass to its maximum travel.

1. WARNING: Place a shop towel between the exterior rear view mirror glass and the hand to avoid personal injury in the instance of glass breakage.
   Grasp the outboard edge of the exterior rear view mirror glass and pull outward.

1. Remove the exterior rear view mirror glass.
   • If equipped, disconnect the heated rear view mirror glass electrical connectors.

Installation

1. If equipped, connect the heated rear view mirror glass electrical connectors.

1. NOTE: An audible click will be heard during installation.
   Press firmly in the center of the exterior rear view mirror glass until it snaps onto the exterior rear view mirror motor.

I belive you are right in saying it is just the direction switch because i have never heard of both mirrors going out just like each other and at the exact same time. you do not need to go to a dealer to get the switch but you can go to any parts store and get it and this will save you about 25-50% off the acura dealers price

are you trting to tighten the mirror glass or the mirror where it attaches to the body? I don't think glass is removable in 99. Only can try to press on glass to seat if unseated. not too hard.

1. Remove the front door trim panel; refer to Section 501-05 .
2. go to car-part.com for a used mirror. Page with * is cheapest seller.

1. Remove the speaker.
   1. Remove the screws.
   1. Disconnect the electrical connector.
   1. Remove the speaker.

1. Remove the outside rear view mirror (17682).
   1. Disconnect the power mirror wiring clips.
   1. Remove the outside rear view mirror nuts.
   1. Remove the outside rear view mirror.
      • Feed the power mirror wiring through the opening in the front door (20124).

------------------------------------------------------

----------------------------
SECTION 501-09: Rear View Mirrors 2001 Explorer/Mountaineer Workshop Manual
REMOVAL AND INSTALLATION Exterior Mirror Glass, 2001 model Removal
NOTE: Exterior mirror glass is serviceable only on vehicles built after July of 2001.
NOTE: Passenger side exterior mirror shown, driver side exterior mirror similar.
All mirrors

1. Position the glass in the full up position.

1. Locate the notch at the bottom of the exterior mirror glass.

1. Release the exterior mirror glass.
   1. Insert a long flat-bladed screwdriver in the notch.
   1. Push the screwdriver into the notch until the glass is released.

Heated mirrors

1. Position aside the exterior mirror glass.

1. Disconnect the electrical connectors.

All mirrors

1. Remove the exterior mirror glass (17K707) passenger side or (17T675) driver side.

Installation
Heated mirrors

1. Connect the electrical connectors.

All mirrors

1. Position the exterior mirror glass on the exterior mirror motor.

1. Place a hand against the back of the exterior mirror housing and a hand flat against the exterior mirror glass. Press the glass in place until fully seated.