My 95 isuzu truck starts runs good for a few seconds then dies. I replaced the mass air flow sensor with no luck what should I do next???

ok lets start with the codes they say your getting. P??? which 1's and how many. there are few o2 sensors, are they next to the Exhaust next to the converter? MASS AIR FLOW -MAF use this, for now i am guessing, until i see the correct codes your are getting. this could be the 1 you may have below, please read it........

• P0103
  Mass Air Flow Sensor Circuit High Input
• Possible causes
• Faulty mass air flow sensor
  - Intake air leaks
  - Dirty mass air flow sensor
  - Dirty mass air filter
  - Mass air flow sensor harness is open or shorted
  - Mass air flow sensor circuit poor electrical connection
• Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
• possible symptoms Engine Light ON (or Service Engine Soon Warning Light)
  - Engine stall
  - Engine running rough
  - Excessive fuel consumption
  - Excessive smoke
• the code is generated when An excessively high voltage from the sensor is sent to Engine Control Module (ECM).

2003 NISSAN Altima Sedan OBDII Codes List

i think this car has a vaccum activated fuel pressure regulator could be your problem also a large vac leak would do this as well

I would check for trouble codes in the computer and fuel pressure next.
You need to figure out if you are dealing with a no spark or low fuel pressure issue to proceed.

P0101 ISUZU - Mass Air Flow Circuit Performancehttp://engine-codes.com/p0101_isuzu.htmlForum CodePossible causes- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor electrical circuit poor connection
- Intake air leaks
- Faulty mass air flow sensor
Tech notes Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor

u may need to have ur computer reset, u dont say if u have any warning lights on the dash. other fuelling system sensors tie in with the air flow sensors. plug ur diagnostic port in at a garage and see what fault code reads.

The mass flow sensor on the 1999 intrigue is along the intake tube right after the air filter intake housing. Loosen the two clamps that hold the MAF sensor between the Air filter box cover and air intake tube, disconnect the wire leads at the MAF sensor connection and remove the MAF. Note it's uncommon for the MAF sensor to go bad and 95% of the time, cleaning it with MAF sensor with MAF cleaner will fix any problem it may of had to trigger the DTC codes.
Start with trying to clean it first just by following the instruction on the MAF cleaner. This should save you time and money to get your Intrigue running 100% again soon.
Good luck and thank you for using Fixya.

try the control module

this may not be the fuel pump. try unplugging the mass air flow sensor to see if the car will run now. in the car will run replace the mass air flow sensor. you state the car will run then die. the fuel pump sounds like it is working. you may not have fuel volume and that may be the problem

Mass air flow sensor.

hi there, when air flow unplugged, ecu goes into limp home mode ,a back up if something dies whilst driving. it sounds as if your used mass air flow sensor is faulty , they are more fragile than they look, one knock and these early fine wire models are gone. i replaced many when i worked at a volvo dealership a few years ago. hope this helps, and good luck.