Light blinks showing 4741 KM to service. What

What make , model an year vehicle ? Could mean a few different thing's depending on the vehicle. But with the light on DTC'S - diagnostic trouble codes are stored in one of the vehicles computers . From transmission problems to electronic throttle control to body control module problems .

If you have service or check engine light turn on, will need to scanned the PCM (Powertrain Control, Module) to know exactly what fault code is stored there. With this code number we could send you additional details to solve it. Some Autozone or Autoshops with scanner reader codes make this job for free (sometimes).

Hope this helps and just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa.

The "INSP" message becomes flashing on the dash after 15000 km or after 1 year, depending which one occuring first. Therefore even the car has been serviced at 169000 km and now has 176000 km, it's very probable that one year had passed.

Service reset



1. Turn the ignition OFF.
2. Press and hold the reset button [1] (see the above picture).
3. Turn the ignition ON.
4. "SERVICE" appears on the display.
5. Release the button [1].
6. Turn the button to the right.
7. The service indicator shows: "---".
8. Turn the ignition OFF.
9. The system is reset.

if the check engine lught blinks it usually means you've got a lttle problem. steady could mean a bigger engine or transmission problem. My engine light came on, I had it checked it showed a huge vacuum leak. my gas cap needed replacing end of light.

Code p0300 is the code for "random missfire detected". The "check engine" light is flashing to warn you that severe damage is being done to the catalytic converter.(very expensive)..

i would say it is just reminding you to to get the vehicle serviced its not major but most vehicles need to be serviced on a regular basis i think every 5000 km

Sounds to me like it may be a sensor in the transmission. Possibly the shift seleniod or the od sensor itself.

Service engine light is on and no codes are showing?

Well barwest , you should always have code 12 ,,, 1 blink then 2 blinks , this is not a prob it is a code to tell you that the onboard dyignostics is working. now for the code 55 this means that the code read is done . so the numbers in the middle is really your prob but you are missing a number with the 3 , do the key again and let me know remember your code is after the 1 blink and 2 blinks ,try that ,there is a number missing ok , joe

http://www.samarins.com/diagnose/checken...

http://www.troublecodes.net/articles/myt...

Make sure the gas (fuel) cap is on properly. Read the codes out yourself:

http://www.amazon.com/dp/B0007LEG2K?tag=...