2007 Jeep Grand Cherokee interior lights our

Question edited to toss in some CAPS.

Question moved to model category.

Jeep Grand Cherokee (WK; 2005-2010) fuses and relays

https://fuse-box.info > jeep > jeep-grand-cherokee-wk-...

Here you will find fuse box diagrams of Jeep Grand Cherokee 2005, 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels ...

2008 Jeep Grand Cherokee fuse box diagram - StartMyCar

https://www.startmycar.com > ... > Fuse box

The 2008 Jeep Grand Cherokee has 3 different fuse boxes: ... Jeep Grand Cherokee fuse box diagrams change across years, pick the right year of your vehicle:.

2005-2010 Jeep Grand Cherokee WK Fuse Box Diagram

https://knigaproavto.ru > ... > Jeep > Grand Cherokee
Oct 7, 2019 - Fuse Box Layout Jeep Grand Cherokee; engine: 3.0L Deisel, 3.7L, 4.7L, 5.7L and 6.1L (WK; 2004, 2005, 2006, 2007, 2008, 2009, 2010)

• 
  

  Grand Cherokee » Fuse Diagram

  https://knigaproavto.ru > Fuse Box Diagram > Jeep
  
  Fuse Box Layout Jeep Grand Cherokee; engine: 3.0L Diesel, 3.7L, 4.7L, 5.7L and 6.1L (WK; 2004, 2005, 2006, 2007, 2008, 2009, 2010)

You can try doing a re-calibration of the cluster. To do that.....
Begin the test with the ignition switch in the OFF position. 2. Depress the odometer/trip odometer switch button. 3. While still holding the odometer/trip odometer switch button depressed, turn the ignition switch to the ON position, but do not start the engine. 4. Release the odometer/trip odometer switch button. 5. The instrument cluster will simultaneously begin to illuminate all of the operational segments in the VFD units, and perform a bulb check of each operational LED indicator. The VFD segments and LED indicators remain illuminated as each gauge needle is swept to several calibration points and back. If a VFD segment or an LED indicator fails to illuminate, or if a gauge needle fails to sweep through the calibration points and back during this test, the instrument cluster must be replaced. 6. The actuator test is now completed. The instrument cluster will automatically exit the self-diagnostic mode and return to normal operation at the completion of the test.

A common fault disconnect the neg battery lead give it 20 min re connect should cure your problem.
Other tips about this can be found on Cnet:

• CNET
• Forums
• Electronics forums
• Car Tech
• The Famous Jeep Grand Cherokee Electrical Problem

Found these three fuses for instrument. Not only check the fuse, use a test lite and check voltage on fuse circuit. As you can see, one fuse is hot all the time, one goes hot with key on, the other rheostat controlled. I saw two ground wires, the primary color for both is black.
As far as instrument cluster illumination, there may be other fuses. You may have interior dimmer control where you can brighten and dim interior lamps.

............1994 Jeep Grand Cherokee
......(Fuse Block - Passenger side of Dash)
.....1........5........9........13........17........21........25
..20 A...15 A...20 A....20 A....7.5 A.....15 A....30 A
.
.....2........6.......10.......14........18........22........26
..15 A...15 A...10 A....20 A.... 15 A.....15 A....30 A
.
.....3........7.......11.......15........19........23........27
..20 A...15 A...15 A.....3 A......15 A....15 A.....10 A
.
.....4........8.......12.......16........20........24........28
..15 A...15 A...15 A....20 A.....10 A....7.5 A....30 A
1)Trailer Tow Relay
2)Brake Lamps
3)Hazard Lamps
4)Security Lamp
5)Interior Lighting
6)Security Alarm Module
7)Security Alarm Relay, Security Alarm Module, Flash-to-Pass
8)Overhead Console, Keyless Entry, Radio Memory/Clock
Memory/Chime Module, Power Locks, Power Mirrors,
HEVAC and VIC
9)Rear Wiper
10)Radio
11)Cigar Lighter
12)Parking Lamps, Automatic Headlamps
13)Horn Relay
14)Power Lock Relays
15)ABS Module and Relay
16)Turn Signals
17)Heating and Air Conditioning Module
18)Airbag Module
19)Interior Mirror, Auto Headlamps, Overhead Console,
VIC/GDM Module, Heated Rear Window Relay Coil,
Illuminated Entry Relay and Chime Module
20)Heated Rear Window Switch, Overdrive Switch, Speed Control
21)Security Alarm Module, Lamp Outage Module
22)Airbag Module, Speedometer, Tachometer, Telltales and
Gauges
23)Heated Mirror Feed, Heated Rear Window Switch
24)Instrument Panel Illumination
25)Power Seats
26)Power Windows, Power Sunroof
27)Security Alarm Module and Front Wiper
28)Heated Rear Window Relay

check for any ground or losse bulb connection.

Have you tried checking the dimmer switch for your instrument panel? I believe if the switch is slid all the way up it will cause the interior lights to stay on. Hope this helps.

Aloha,
Kalani

if you are talking about the yellow engine symbol in the instrument cluster it is telling you there is some kind of problem and you ned to have the codes checked to get an idea what it may be

Unfortunately, could not find owners manual for 1996.

Website only has models 2004-current
=> http://www.jeep.com/en/owners/manuals/index.html

There are two fuse boxes. One under driver compartment usually left to the steering colum. A label is stamp to identify each fuse. I would look at Park Lights and Instrument Cluster fuses. The easy way is to take a flashlight and look at all fuses. If they are all okay. Then just remove the Park Lights and Instrument Cluster fuse and reseat them. The other fuse box is under the hood and near the batter. It also has a label to identify each fuse.

try unplugging ur inst. cluster putt the fuse in and check for 12 volts at the plug for inst. cluster if it is there the issue is with the cluster if voltage is not there it is from the plug back