2001 chevy s10 loses power, will not stall, restart runs better.

Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html

Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...

Check for trouble codes.

when engine light blink it is only one thing.......misfire you could have P0300,P0301 and so on
P0300 is multiple misfire
P0301 is cylinder no 1 misfire,the last number tell you the no cylinder
hope it helps

Can you perform a spark test? I would like to know if it has spark when it stalls. Also, if you have a can of starter fluid, wait for it to stall and not want to restart, the quickly spray some starter fluid into the intake. If it runs on the starter fluid, you have a fuel issue. You might also want to make sure the engine coolant level is fine and you aren't overheating. If you coolant level is low you may not know it is overheating since the coolant sensor isn't in coolant. It won't read air.

cold engine idle surge. (problem)
RPM range of surge not stated
300-700 or 800 to 1500? (range is critical to diagnosis)

bad fuel
running summer fuel in winter (running old fuel?)
needs a tune up bad, see the list in the operator guide.
idle speed controller,sticking or EGR valve same. (clean them)
location not stated, so cant guess about local air temps.?
no other symptoms, lack of engine power? etc?
was it ok last week, or better, when was the last time it was OK?
1week, 1year?
surge , causes, on a tuned engine might be:
1: too lean. so lean the ISC can not control idle. rpm low, stalling
2: too rich, flooding, stalling, spark plugs foul (look at them)
3: weak compression in 1 or more cylinders.
4: bad spark.
5: air leaks, in the plenum causing , ISC to lose control.
why high RPM?

especially?
well that means it fails hot too.
and there is a simple tests. for hot surge.
is engine fully hot? 180F and holds solid there?
say rpm is about 800
and you turn on head lights, heater fan and (not AC) and defrost.
the RPM must hold or the ISC is failing.
ISC -= idle speed controls. (all EFI has this function)

First thing you need to get the trouble code out of the computer.

The white smoke is probably steam caused by coolant getting into the cylinder(s) either from a faulty head gasket, cracked cylinder head or cracked engine block. The loss of heat from the heater indicated that coolant was being lost..

check your fuel filter, it may be dirty and not letting enough fuel through.

have you tried reseting the computer
disconect the batery and wait 5 mins then re conect the baterie

Possible warped cylinder head, or cyclinder head gasket.