How can i reset the oil change indicator on a 2008 lexus is 250??

2008 Lexus IS250 AC low pressure charging port is located on the driver side close to brake booster. I accidentally saw it while changing the O2 sensor.

You can find the oil life monitor reset procedure here

Oil Change Light Reset Audi Q7 2007 2008 2009 2010 Reset Your Oil Change...

1.With the car turned OFF, locate and hold down the odometer reset stick on the instrument panel.
2.WITHOUT your foot on the brake, press the engine start button twice while holding down the odometer reset.
3.Now...Your odometer reading will show some dashes that begin to go away one at a time. When the go away you are finished and your next scheduled maintenance has been reset in your IS computer and will alert you again at that time. Hope this helps
Read more: How to reset your oil change light on a Lexus IS250 or IS350 ' eHow.com http://www.ehow.com/how_5210681_reset-oil-change-light-lexus.html#ixzz1ZDyReSum

The following procedure will reset your oil change light. Thank you for using Fixya!

2008-2010 Sable

1. Turn the ignition to run (one position before starting engine).
2. Press and release SETUP to display "OIL LIFE XXX% HOLD RESET = NEW".
3. Press and hold RESET for 2 seconds and release to reset the oil life to 100%.
4. Turn the ignition off and then start the engine to verify the indicator has been reset.

Oil light needs to be reset. If you still have owners manual the reset procedure should be in the manual. If you had you lexus serviced at the dealership just take it back to them and ask them to reset it.

Turn ignition on, press trip button till you see trip A. Turn ignition off, press the trip button and turn the ignition on while you hold the trip button, once the 5 dashes flash away it will reset.

Unhook the battery for about ten minutes... that should take care of it..


Robert

Please take a moment and rate this solution.. thanks

1. turn engine off , 2. press trip meter reset knob and hold it , turn ignition on , with the engine off, continue to press and hold reset knob until the trip meter displays "00000" , reminder light will turn off . if system fails to reset , repeat procedure . +

PRESS AND HOLD IN THE TRIPOMETER RESET BUTTON. WITH IT IN, TURN THE KEY TO THE ON POSITION WITHOUT STARTING THE ENGINE. THE DISPLAY WILL COUNT DOWN IN HASH MARKS FROM 6 TO 0. AFTER IT REACHES 0 RELEASE THE TRIPOMETER RESET, TURN THE KEY TO THE OFF POSITION. ONCE YOU RESTART THE LIGHT SHOULD BE OFF.