How do I replace a burned out backup light on a 1998 cheverolet silverado c-1500 pickup truck?

Hi!!

Just remove the screws holding the tail light assembly and pull it out, twist BKUP light socket and pull bulb out. I suggest you by replacement bulb before doing this so you don't have to do the job twice.

Don't forget to rate this post. Good Luck!!

Removal & Installation Cab/Chassis

To Remove:

1. Disconnect lamp assembly electrical connector.
2. Remove nuts and lamp assembly from bracket.
3. Remove lens screws.
4. Remove lens, gasket and bulb.

1. Install lamp assembly and nuts to bracket.
2. Connect electrical connector.
3. Install bulb, gasket and lens.
4. Install lens screws.

1. Lower endgate.
2. Remove 2 tail/turn signal lamp assembly retaining screws.
3. Rotate tail/turn signal lamp assembly and remove from vehicle.
4. Disconnect lamp assembly electrical connector.
5. Remove bulbs by pulling straight out of bases.

1. Install bulbs by pushing straight into bases.
2. Connect electrical connector.
3. Install tail/turn signal lamp assembly to vehicle and secure with 2 screws.