SOURCE: How to check transmission fluid
Easier done on a lift, but you need to start the vehicle and let it warm up and then remove the fill plug not yhr drain plug, (with the vehicle running) the plug will be found on the transmission pan but it is NOT the one on the very bottom of the pan, there is another plug up in the corner of the pan on the passenger side. Remove this plug carefully, for the fluid will be warm to hot, if a little runs out of the hole your ok, if nothing comes out with the plug completely removed you need to add a little at a time thru this hole until it runs back out. DO NOT SHUT THE ENGINE OFF WITH THIS PLUG OUT, fluid will run out if you do.
To get fluid in the hole, attach a small hose to a filler top off of a gear oil bottle and put that top on your tranny fluid bottle, turn it upside and squeeze the fluid in using the hose to get it into the pan. If you have a fluid pump it would be better but if not this will work.
SOURCE: 2001 Isuzu Rodeo transmission
get a fluid injection syrynge make sure the truck is hot take the recessed bolt out and injeect dexron3 trans fluid into it until it drips out
SOURCE: how to check transmission fluid on 2001 isuzu rodeo
There is no dipstick on your auto trans. Checking it is a real PITA The trans pan has 2 plugs in it. The one on the very bottom is the drain. The one in the corner, up higher in a recess is the check/fill plug. To check, the engine must be warm and running, tranny in P. Remove the plug and fluid should dribble out. If it doesn't it's low, fill until it dribbles out, while engine is running. Obviously the truck must be on a lift or up on jackstands.
4,641 views
Usually answered in minutes!
×