At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
well if you car has the two part headlamp take out the turn signal housing. and slide out the headlamp housing out in the direction to where you remove the turn signal housing. if you have the one piece housings you have to completely remove the front bumper to remove the headlamp housing
would you believe that the front of the car slides forward about 3"...if you remove the front bumper cover you will see the bolts both sides that allow access,sorry i do not have a scematic to send you......
If you are talking about the passengers side than you will need to remove the bumper cover start by removing the screws in the fender and remove the liner remove the side lamps and screws on top and under the front of the bumper you will see the crash sensor mounted to the support ONE question those sensors rearly ever go bad way r u replacing it?
you will need to remove both rear tail lights remove the screws on top and under bottom and in the fender wells there will be a lot of screws when you get done
you have to take off head lights and signals because there is a bumper bolts behind them ,remove engine shield underneed and front tires splash shileds front side bolts ,take off front grill there is a bolts forr bumper too.
and you may need the get your a/c refrigrant **** with recycling machine because condenser and radiator come out togethar so you have to disconnect a/c lines from the condenser to take out radiator. good luck!!
Your car is may overheats for diffrent reason just make sure problem is the radiator or thermostat if its not you still gonna have same problem after at all.
If the light casing needs replasing then im pretty sure you have to remove the upper bumper, but if its the bulb thats blown the you should be able to do it from the engine bay. I hope this information helps im sorry i couldnt help more but im not a vw specialist.
you need to remove front bumper , remove front into service position , remove aux belts set timing marks up ( you will need to use locking tools ) lock crank and cam shaft remove belt replace belt and tensioners . please note it is also use full to check water pump
×