2004 X5 our centre rear seat belt locked while the rear seat was lowered down flat, we could not raise the seat until we freed the belt - by unscrewing the holding bolt under the seat cushion
how can we get into the seat belt assembly as recommended in the seat belt locking solution?
SOURCE: centre rear seat belt will not pull out
You'll need to remove the covering off your seat belt assembly to see if it's knotted up inside the case or if the tensor switch is set too tight or it's locking
SOURCE: Drivers side seat will not
I had the same problem. It turned out that the previous owner(s) had let a lot of sticky trash accumulate under the seat. After the seat was removed and everything (seat tracks and floor) was given a good cleaning, the seat goes up and down just fine.
SOURCE: 1995 BMW 525i seat height motor works on one side of seat only
there are 2 cables that come out of the motor that operates that feture. Over time the outsdie tube of the cable streaches, causing the cable that turns inside, to come out of the transmission is drives. One way to fix this is to remove this cable and shoren the outside tube by cutting it, and then re-insall back into the transmission. This is a 50/50 chance repair. The correct way to cure this issue is to replace the lower seat frame. $$$
SOURCE: They will not operate at all. stuck down so i can
i assume your talking about the windows??if so locate the rubber boot going from the door to the fender and try wiggling it while pushing the switich with the key on.the problem is usually in this harness where it pivots each time the door is opened.
SOURCE: I just go locked out of my X5 BMW 2002 x5 and my
right i had this ***** of a problem 2nd week in jan 2010. a bmw mechanic told to jack car up at front and hook a jumper pack up to live on starter motor terminal and then earth, was quite hard to put croc clip on to starter but did manage it. this was supposed to back charge to battery to get enough power to open car with remote, in theory it should of worked but i gave up after 3 hours-no power. so i got my key put it in drivers door and mechanically turned to open position, then i got a cutlery knife from kitchen and wrapped some insulation tape around tip up 2-3 inches. then i pushed this down glass directly above door handle key end to pry a gap between glass and rubber just enough to slide coat hanger wire in with small hook on end then i manouvered wire hook until i hooked latch arm which i did within 1 minute pulled coathanger wire up and pulled door handle the door opened much to my delight. this was a major sigh of relief after trying for 2 days to get in, and many hours searching the net for a solution which i couldnt find. THIS WORKS 100 percent WITH ABSOLUTELY NO DAMAGE!!!!!!! any questions email me- [email protected]
284 views
Usually answered in minutes!
×