Car alarm will not shut off-- can not start vehicle--

GOT OPTION "ENTER AND GO"???????????????
did you use both FOBS. car came with 2, try using both , one at a time and not both near car as SAME time. ever.

mines turned off for ever,
i never armed it.
so page what.
wow 6 owners manuals, 4 for Uconnect, wow. pain.
page 22. read that?
sure.
is this not clear ,quoted
The Vehicle Security Alarm is designed to protect your
vehicle; however, you can create conditions where the
Vehicle Security Alarm will arm unexpectedly. If you
remain in the vehicle and lock the doors with the RKE
transmitter, once the Vehicle Security Alarm is armed
(after 16 seconds), when you pull the door handle to exit,
the alarm will sound. If this occurs, press the UNLOCK
button on the RKE transmitter to disarm the Vehicle
Security Alarm. You may also accidentally sound the
Vehicle Security Alarm by unlocking the driver's door
with the key and then opening the door

good luck deciphering this page, wow.!
page 23 is NO ENTER AND GO', OPTION.
Either press the UNLOCK button on the RKE transmitter,
pull on the front driver or passenger door handle (refer to
"Keyless Enter-N-Go" in "Things To Know Before Starting
Your Vehicle" for further information) with a valid
key fob in range, or press the Keyless Enter-N-Go Start/
Stop button (requires at least one valid Key Fob in the
vehicle), or insert a valid Key Fob into the ignition switch
(if the Start/Stop button is removed) and rotate it to the
ON/RUN position.

END QUOTES FROM YOUR GUIDE.
if all this fails get jeep to fix it. (the magic is broken so...)
or ask them to explain, page 23 , in non GREEK..

you may have gone past a setting of a sensor and the CPU shut it down .try resetting the CPU with a code reader and read any faults that were recorded as well

sounds like your factory alarm is not working with the remote starter. it happens a lot with the new cars. check the BCM that runs the factory alarm.

dead battery

Use you key to lock and unlock the tailgate as the alarm is sounding. The alarm will shut off and vehicle should start.

Probably a fuel pump beginning to fail.

shoud shut off by turning key in the ignition ... check the manual for your vehicle on how to resync your trasmitters

To reset the alarm: with your keys on the keylocks do "lock/unlock will reset the alarm an enable you to start the vehicle . I dont know which door is yours but try it on the two front doors and the trunk door. Mine is on the trunk. Good luck. Nixon.

you must to restart your car alarm

use the key and unlock the trunk...if that doesnt work do the passenger door...that should reset the alarm...