SOURCE: Can't remove headrest
I'm not positive about that model, but some of them had a button that you pushed built right into the seat, right beside where the shaft for your headrest goes in. Just push beside the shaft on either side of the post with your thumb.
SOURCE: 2009 toyota rav4 rear headrests
You can pry them back and they should tilt. Otherwise pull up real hard and they will come out.
SOURCE: the angle of the headrest is too far forward on 2010 ford focus
try cleaning battery connections and starter connections if this does not help check timeing may be out. check nfor possible over heating. berrydalewolf
SOURCE: 2002 Mazda Tribute rear liftgate lock replacement
I'm not sure where' the screws are but basically You need to remove the panel on the rear door, then once the panel (interior trim) has been removed you should see a lock mechanism which will be screwed/bolted in place. Easier and cheaper then buying a brand new lock mechanism (unless you want to buy brand new) is going to a wreckers and finding your car model and get it that way (yes it's used but it'll probably save you tons of money vs the dealership) Best Regards.
SOURCE: headrest inserted backwards and now unable to
On my 2003 Jeep, there is a button on one of the two round plastic bases in the top of the seat. The button is actually molded the shape of the base. Depress it while pulling the headrest upwards.
235 views
Usually answered in minutes!
×