How to turn off brake warnni9ng light and traction control back on on my 2000 pontiac gran prix let the pads and rotors get to low changed them but light still on is there a fuse for the traction control

I think you can take a OBD2 code reader to have a check, and you will know what problem cause the lights on.
_________-
car diagnostic tools

Hi , Sounds like you need new pads on the front. That squealing is a indicator that th brakes need to be replaced. Also you need to check the computer codes for your brakes system. Go to a repair shop for that. Good luck.

Does now ! change your caliper, rotor and pads, because pads and rotor have overheated from caliper setting up and not floating like should !!

Could be lose wire on alternator if light come on check belts

is this the front brakes doing this?? or the rear?? i would recomend changing pads and rotors and drums(rear) and shoes(rear)

Nope, the traction control system will not be an issue, just do not damage or strain any wiring, same as you would not damage or stress the brake lines.

remove the caliper, by removing the two holding bolts, then use a old brake pad against the pistons and a c clamp and push piston all the way in, next is to clean and lube pad mounting surface and the caliper slide pin, then install new pads on bracket then caliper and tighten caliper bolts, heres a diagram to help you,

the traction control uses the same sensors as abs, could be a sensor or even a wheel bearing, get the brakes inspected

recheck the sensor most likely not properly hook up or attached to clip

is it the brakes or a poss bad hub bearing?.....hhhmmmm