How do i remove the driver's inside panel door? My electric button panel for windows and locks isn't moving.

Like reference guide, check this procedure to Removal & Installation / Door Lock Motor...

The door lock motor is integral with the door latch. If the door lock motor is found to be defective, the entire door latch must be replaced.

1. Before servicing the vehicle, refer to the Precautions Section.
2. Roll the door glass down.
3. Disengage the 2 clips attaching the speaker grille to the door trim panel. (They are at the front of the grille, one near the top, and the other one at the bottom).
4. Remove the 3 large washer-headed screws surrounding the speaker.
   
   
   Fig. Fastener location for the door lower trim panel
   
5. Remove the access cover at the front of the door trim panel. Remove by prying at its rear edge.
6. Remove the red courtesy reflector from the lower tail of door. Disengage by prying at the screwdriver notch at the bottom of the reflector.
7. Remove the flag trim panel from the door by prying it off at the 2 attachment clip points.
8. Remove the 7 screws attaching the door trim panel to door:
   1. One screw is located at the lower rear screw pocket.
   2. Three screws are located along the bottom of the door.
   3. One screw is located inside the handle opening.
   4. One screw is located at the upper front.
   5. One screw is in the pull cup.
      
9. Disengage the 2 hidden clips attaching the rear of the trim panel; pry them off at the 2 attachment clip points.
10. Lift the trim panel upward and away from the door, disengage the trim panel from the upper retainer channel.
11. Disengage the clip attaching the latch linkage to back door handle.
12. Disconnect the electrical connectors as necessary, including the lower foot light, if equipped.
13. Remove the door trim panel from the door.
14. Remove the water shield (water dam) from the inside of the door.
    
    
    Fig. Remove the flag trim panel, door trim access cover, inside remote handle, and power door lock switch
    
15. Raise the door glass.
16. Remove the bolt and nut for the rear glass run channel and position the channel aside.
17. Disconnect the lock rod from the lock button bellcrank.
18. Disengage the lock and latch rods from the clips on the inner door panel.
19. Disconnect the lock and latch rods from the outside door handle and the key cylinder at the door latch.
20. Disconnect the wire connector from the power door lock motor.
21. Remove the screws attaching the door latch to the door end frame.
22. Remove the door latch and the power door lock motor from the vehicle.
    
    
    Fig. Expanded view of the door lock, latch, and linkage
    
    
    
    Fig. View of the door lock button, latch rod, lock rod, and door latch