When I crank my car in the mornings, it will not shift into gear. It is difficult to change gears for a couple of minutes, then as I'm driving it seems to be OK after it is warmed up. If I stop for any length of time, then it is difficult to move the stick into gear. I definitely have the clutch pedal depressed all the way. I appreciate your diagnosis and suggestions.
SOURCE: rover 600 1997 not engaging any gears when clutch fully depressed
Sounds like the SLave Cylinder has givin up Possible the Reli=eice Bearing I ALWAYS Replace As A PAIR . If you can put in gear by having someone rock the car front to back and it holds well its pretty Obvious that you DO have A Clutch Master Cylinder or Clutch Slave aat Releice Bearing Problem AGAIN These Parts I REPLACE AS A PAIR. Before ANything Chech Fluid Level that will tell the store IF FULL Most Probably MASTER-- If EMPTY then See where it went Look At SLAVE if wet thats the Culpret. --->> I Hope this INFO helps you and have a good Day >> Please dont forget to RATE me ok ? Thank You
SOURCE: daigram of 1995 Honda Civic EX plug clutch pedal ?
95 civic coupe ex brake lights wont work and the shifter locks in park position, what's wrong?
SOURCE: 97 civic ex MT clutch "flops", very little resistance
check the brake and clutch fluid resiviors.
if low add dot3 brake fluid.
but if sounds like the clutch is done.
about $800 to replace .
SOURCE: Honda civic vti 1994 clutch pedal adjustment
you mite have 2 change your pressure plate. unless its ran by fluid.
SOURCE: 99 civic clutch hangs
you may still have an air pocket in the line try bleeding it a little more
159 views
Usually answered in minutes!
I double-checked that the all fill reservoirs are full... especially the one that keeps the clutch pedal working... still I have the same problem... difficult to shift into gear.
I have to pump the clutch pedal several times prior to starting the engine,,, so that the shift will move into gear.
×