Check this procedure...
The following removal steps require the help of an assistant.
continue...
To install:
Carefully install the instrument panel through the left front
door.
Carefully position the instrument panel on the firewall.
Install the three bolts and one nut attaching the instrument panel
to the left cowl side panel.
Install the two rearward nuts, then install the two forward nuts
located to the right of the steering column, attaching the instrument
panel to the center mounting bracket.
Install the one nut attaching the lower right side of the
instrument panel to the cowl side panel.
Install the five screws attaching the top of the instrument panel
to the cowl side top panel.
Attach the heater temperature cable. If equipped, attach the
vacuum hose harness connector.
Attach the radio antenna lead-in cable at the right cowl side
panel.
Attach the wiring to the windshield wiper intermittent control
module and, if equipped, the wiring to the low oil level relay. Both are
located to the right of the steering column.
Attach the transmission control selector indicator to the steering
column.
Install the extension shaft to the steering column U-joint.
Install the steering column-to-extension shaft pinch bolt.
Attach the brake light switch wiring connector. Attach
the clutch pedal position switch on manual transmission equipped
vehicles.
Attach the wiring on the left cowl side panel and, if equipped,
the vacuum hose harness connector. The number and location of the
connectors may vary depending on optional equipment.
Remove the two nuts retaining the hood latch control handle and
cable assembly to the left cowl side, install the control handle and
cable assembly, then reinstall the nuts.
Install the right and left cowl side panels.
Install the four bolts attaching the steering column lower
reinforcement. Install the reinforcement.
Install the instrument panel steering column cover.
Install the glove compartment door finish panel.
Install the defroster grille.
Install the left and right windshield inside mouldings.
Attach the wiring connector for the instrument panel located, in
the engine compartment. Install the bolt, then tighten until snug.
Connect the negative battery cable.
Hope helps (rememner comment and rated this).
×
372 views
Usually answered in minutes!
×