SOURCE: 1991 mighty max
If it is 4X4 and you re not going far. Put the transfer case in neutral. If it is 2X4 standard transmission, put it in neutral. If it is an automatic transmission you need to remove the driveline.
SOURCE: 95 mitsubishi mighty max main required light
If you are speeking of the check engine light you can disconnect the battery for a few minutes then reconnect it and the light should go off.
SOURCE: what type of oil should
with it being an older vehicle with high milage a 10w40 oil would be my suggestion.
SOURCE: Need the valve gap for 1991 mighty max
Does not have adjustable valves . It has hydrolic valve lasher's . they are spring loaded ( i believe ) . I just replaced them in mine . valve giude seal's where worn out causing it to smoke realy bad ( looked like a mosqito truck ) and the valves where ticking , due to the hydrolic valve lash adjuster's being worn out . They are about $ 8 - 10 buck's each at advance .
SOURCE: Torque specs for mighty max
Per my Chilton's manual tehe bolts should be (cold engine) 65 to 72 FT. Pnds., the cam shaft bearing bolts should be 8x25 = 15 - 19 Ft pnds and the 8x65 should be 14 - 15 Ft Pnds.
The sequence is as follows for the (10 ) head bolts:
7 - 5 - 2 - 4 - 10
9 - 3 - 1 - 6 - 8
I hope this may help,
Tom
2,330 views
Usually answered in minutes!
×