Need timing marks for a 98 chevy malibu, 2.4 quad motor

here you go

Fig. Align the timing mark on the crank sprocket (2) to the mark on the bottom of the timing chain damper (1) and the timing mark on the cam gear (4) to the mark on the top of the timing chain dampener (3

Sounds like a fuel pump.

Here ya go!



Align the timing mark on the crank sprocket (2) to the mark on the bottom of the timing chain damper (1) and the timing mark on the cam gear (4) to the mark on the top of the timing chain dampener (3)

99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.

you must check these.
1- IAC
2- injecters
3-valves cylinder
4-fule pressure
5-coil ignition
6-bult timing

Sounds like you need to have a new ignition switch installed. Copy & paste this link into your browzer: http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?displayName=Ignition+Switch&currentPage=1&categoryDisplayName=&navValue=16200189&itemId=189-0&parentId=62-0

squeeze them together and pull them off at the same time or cut them off since you need to replace them

Hi, you wont be able to move the wipers manually as they will be locked by the motor. There is only two obvious reasons why the motor should fail again. The new motor was a poor quality replacement or there is an underlying problem on the car like the wiper motor mechanism has excessive play or is stiff/tight and over working the motor causing it to fail. you need to have a proper check over before swapping it again.

Check with a battery tester if you have power at the starter, Are the Battery post clean, Are any fuses blown in the fuse Box, check for any corrision.