2005 chry sebring crankshaft sensor location - 2005 Chrysler Sebring Conv

Question edited for clarity.
Question moved to model category.

Crankshaft position sensor location - Colorado Fans

coloradofans.com https://www.coloradofans.com > threads > crankshaft-...
Dec 16, 2009 - Hey everyone.. do ya know where the crankshaft position sensor is located on our engines? It would be a big help if someone could point me ...

Crank Positioning Sensor Relearn - Colorado Fans
Oct 7, 2006
No start after replacing Camshaft Position Sensor
Mar 2, 2012
Camshaft Crankshaft sensor ' Chevy Colorado & GMC Canyon
Feb 22, 2015
Colorado won't start after replacing the Camshaft Actuator ...
Sep 11, 2012
More results from www.coloradofans.com
..

Hi Allen,here's a you tube video showing where your sensor is and to replace. 2008 Chrysler Sebring 3 4 crankshaft position sensor locati

On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).



Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models



Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block



Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

It is located under the starter that is for a 4 cylinder engine if you are a six cylinder or 2.7 it is located on the rear of the transmission housing above the differential housing

The crankshaft position sensor is located in the lower front of the engine, near the motor mount. Pretty good video of this job at the link.
Crankshaft Position Sensor Replacement Dodge Stratus Chrysler Sebring...

check code probable p0340 camshaft position sensor. I have the same problem on 2005 sebring sedan. I was told to check the circuit at the crankshaft and camshaft sensors for the proper voltage. I'm still trying to figure mine out. If you find your answer, let me know.

I wasn't able to find out the first engine code, but the other one is a multiple or random misfire. and crankshaft position sensor a circuit. If the car has a distributor you could tried replacing the cap rotor and also wires first. Next you would look at the crankshaft position sensor try unplugging and plugging it back in. Look at the connection and wires to make sure they look OK. If you do not know how to test this you could also just replace the sensor. Good luck.

removal steps (CPS) -remove air intake hose -Battery tray -Crankshaft position sensor

Fig. 2: Location of the crankshaft position sensor on 2.4L engines

the crankshaft position senor on the 2.2L is located on the rear right side of the engine block