Code P1420 suggests replacing the secondary injection pump relay, where is the relay?

Question edited for clarity.
Question moved to model category.

Code P 2444

Jaguar Forums https://www.jaguarforums.com > forum > code-p-244...
Mar 28, 2021 - The secondary air injection pump is in the right front bumper. To access, you need to remove the undertray that covers the bumper. I believe the relay for the ...
XJ 8 Secondary air pump - Jaguar Forums
May 26, 2020
Secondary Air Injection System issues - RESOLVED
Jun 5, 2014
Any Ideas on Occasional P0411 Code? - Jaguar Forums
Apr 13, 2017
Air Injection Pump schematic - Jaguar Forums
Aug 9, 2015
More results from www.jaguarforums.com

https://www.google.com/search?q=2007+Jaguar+XJ8.+Where+is+the+secondary+air+injection+pump

..

This code doesn't mean to replace the air pump ,
DTC P2430 : Secondary Air Injection (AIR) System Pressure Sensor Circuit
Circuit/System Description
The secondary air injection (AIR) system aids in the reduction of hydrocarbon emissions during a cold start. The system forces fresh filtered air into the exhaust stream in order to accelerate the catalyst operation. An electric air pump, the secondary AIR injection pump, provides filtered air on demand to the AIR control solenoid valve/pressure sensor assembly. The AIR control solenoid valve/pressure sensor assembly controls the flow of air from the AIR pump to the exhaust manifold. The AIR solenoid relay supplies the current needed to operate the AIR control solenoid valve/pressure sensor assembly. A pressure sensor is used to monitor the air flow from the AIR pump. The engine control module (ECM) supplies the internal pressure sensor with a 5-volt reference, an electrical ground, and a signal circuit.
This is a pressure sensor problem . What this video on testing !
Chevrolet Malibu P2432 Secondary Air Injection System

AIR SOL - fuse #54 15amp - AIR fuse #56 60amp location under hood fuse / relay box
54
AIR SOL Fuse
15A
AIR SOL Relay, Secondary Air Injection (AIR) Pump Relay, Secondary Air Injection (AIR) Pump, Secondary Air Injection (AIR) Solenoid
55
AIR SOL Relay
--
Secondary Air Injection (AIR) Solenoid

here is what i found on p1416.



P1416 Chevrolet
P1416 Chevrolet - Secondary Air Injection System Bank 2
Possible causes
- Faulty Secondary Air Injection (AIR) pump
- Secondary Air Injection check valve bank 2
- Secondary Air Injection (AIR) pump electrical circuit fault
- Blocked Secondary Air Injection (AIR) system

When is the code detected?

The P1416 code is set when no O2 sensor voltage change is detected by the Engine Control Module (ECM).


Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)


P1416 Chevrolet Description
An Secondary Air Injection (AIR) pump is used on this vehicle to lower tail pipe emissions on start-up. The PCM supplies a ground to the AIR pump relay, which energizes the AIR pump. The Powertrain Control Module (PCM) monitors the HO2S voltages to diagnose the AIR system. During the AIR test the PCM activates the AIR pump during closed loop operation. When the AIR is activated, the PCM monitors the HO2S voltages and short term fuel trim values for both banks of the engine. If the AIR system is operating properly, the HO2S voltages should go low and the short term fuel trim should go high.

Hope this helps
Trouble Code: P2258

Secondary Air Injection (AIR) System Control A Circuit High
Possible Causes:


AIR relay fault - stuck closed Secondary AIR pump fault - circuit open in motor Open ground to secondary AIR pump Open AIR monitor circuit between the secondary AIR pump and the PCM Short to voltage in the AIR relay to secondary AIR pump voltage circuit

p0412 Secondary air injection switching valve A circuit
Right side of engine compartiment. ( underhood fuse block )
- Air pump fuse 50A- Air control valve relay- ignition1 fuse 10A ( positive for the relay )The secondary air injection pump relay is located near radiator surge tank.Left front of engine compartiment = Secondary air injection pump

That's s failure of the secondary air pump. It'll have to be changed. It's an emissions component meant to help with cold start emissions. It won't cause engine running trouble but at inspection time you'll fail for smog. Change it before then and you'll be fine.

16795/P0411/001041


if (window.showTocToggle) { var tocShowText = "show"; var tocHideText = "hide"; showTocToggle(); } 16795/P0411/001041 - Secondary Air Injection System: Incorrect Flow Detected Possible Symptoms

• Malfunction Indicator Light (MIL) ON

Possible Causes

• Fuel Pump Relay (J17) faulty
• Hoses/Pipes to/between Components faulty/clogged
• Secondary Air Injection Pump (V101) faulty
• Secondary Air Injection Pump Relay (J299) faulty
• Secondary Air Injection Solenoid Valve (N112) faulty

Possible Solutions

• Check Fuel Pump Relay (J17)
• Check Hoses/Pipes to/between Components
  • Check Secondary Air Injection Hoses/Pipes for Carbonization
• Check Secondary Air Injection Pump (V101)
• Check Secondary Air Injection Pump Relay (J299)
• Check Secondary Air Injection Solenoid Valve (N112)

The code refers to the secondary air pump. This pump helps reduce pollution by injecting air in the exhaust system for up to 30 seconds at cold startups.


Possible causes:
Bad Air Pump. Fix: replace air pump, it is found low, under the battery
Bad Relay (controls the air pump) :
The relay is in the relay box next to the battery. It is the relay in the left upper corner when looking towards the driver.


A detailed picture I took here: http://imgur.com/RCiLL.jpg

this is most certainly the electric motor driven secondary air injection pump, very prone to failure.
Price at www.rockauto.com $207.00 (lowest anywhere)
AC DELCO Part # 219505 {#17803251}
PUMP,SECD AIR Injection w/ELEC AIR INJECTION REACTOR(K18)