Does anybody know if or where the transmission dipstick is located at. 2003 saturn VUE 2.2L 4-cylinders

Manual transmissions usually don't have dipsticks, there should be a fill hole. Slipping is going to be a clutch problem or might check your clutch slave cylinder level.

I looked at info for 4 cylinder engine, 2.2L
You have to remove starter motor to get at it, so says my database.

check this starter out Starter 2006 Saturn VUE 2WD 4 Cylinders 2 2L MFI DOHC AutoZone com now check this one out,compare the prices on these starters to see. Starter 2005 Ford Escape 2WD 4 Cylinders 2 3L SFI DOHC AutoZone com

1. Switch off the car
2. Pop up the hood and raise it
3. Locate the transmission fluid cap
4. Remove the cap to add fluid
5. Check the owner's manual on what type of fluid your car requires and in what quantity. It is essential to use the right fluid and not anything off the shelf.
6. Remove the dipstick and start filling up the fluid slowly - you don't want to add too little or overfill.
7. Now put back the dipstick, switch on the vehicle and start shifting gears. Remove the dipstick and see the marking to know if you your car has the right amount of fluid
8. Put back the cap by turning it clockwise.

There isn't one

Remove the transmission dip stick and use a small funnel to add fluid. Be careful not to overfill. J.

i own a 2003 vue. it happened to me and finally the tranny went. it was a sealed transmission(cvt)do you have a dipstick to check your transmission fluid.if you dont, get saturn to look at it.a new one is 6000.00.Just hope you have a warranty.

the dipstick is located behind the front transmission mount and its held in by a 12mm bolt. you may need to remove the transmission mount to check the fluid. the color of the dipstick is yellow, make sure the car is in park and fully warmed up to operating temerature and on a level surface before checking the fluid.

You have to take it to a garage or dealership. Transmission has no dipstick. It has a special plug that bolts on where dipstick should be located.

Depends if the engine is 3.0 or a 2.2?
3.0 purge is on the top, back side of the intake. Black, cylinder. Looks the same on a 2.2, but is located next to the air filter.