I need to know how to replace the driver side rear window.

What year make and model is your vehicle

You dont tell us excalty the year of your CRV, so keep in mind that this is the procedure for 2000 Honda Truck CR-V 4WD 2.0L MFI DOHC 4cyl, other year is similar process. If you need take off the window, you need take off the "window regulator", so check this...


Honda CRV/Odyssey 1995-2000 Repair Information

Door Glass and Regulator

REMOVAL & INSTALLATION CRV Models and 4-Cylinder Odyssey Models
(see Figures 1, 2, 3 and 4 )



Fig. 1: Always matchmark any fasteners that are mounted through a slotted hole. This bolt is used to adjust the window position



Fig. 2: The window is raised just enough to access the mounting bolts



Fig. 3: Once the window fasteners are loosened, the window can be tilted and lifted out of the door I need to know how - 001509f.jpg


Fig. 4: Slide the window motor/regulator assembly out of the door

1. Remove the door panel, as outlined in this section.
2. Remove the plastic vapor barrier.
3. On 4-cylinder Odyssey models rear door glass, remove the center rear channel bolt and remove the channel.
4. Carefully raise the door glass until the bolts are visible.
5. On 4-cylinder Odyssey models rear door glass perform the following:
   1. Remove the self-tapping screws from the outer triangular trim cover and remove the cover.
   2. Remove the door glass bolts.
   3. Carefully lower the glass, then remove the bolts and nut from the rear lower guide channel.
   4. Remove the glass from the rear guide channel.
   5. Apply protective tape around the painted surfaces of the window sash trim.
   6. Tilt the window forward and remove from the window slot.
      
6. Loosen the bolts, then slide the lower guide forward and remove the window from the guide.
7. Carefully pull the glass out through the window slot. Take care to not drop the glass.
8. To remove the regulator, perform the following:
   1. Scribe a line around the rear roller guide bolt to mark its original position.
   2. Disconnect the electrical connector and harness clip, then remove the regulator mounting bolts.
   3. Remove the regulator through the hole in the door.
      
9. Installation is in reverse order of removal. Apply grease to the rollers, guides and sliding surfaces of the regulator. Make sure to install the roller guide with the rectangular hole facing rearward. Check the window operation before installing the door panel and adjust if necessary.

1.) remove upholestry on door,, it has a few hidden screws, loke under the handle is a cover with it etc.. remove them and them pull upholestry off the door to seperate the clips..

2.) send window up,, u will notice the glass moves on a metal rod spline and is attached to it by means of a few screws on a bracket..

3.) have someone clasp the glass with both hands, as u remove the screws,, tilt the glass back then lift up and out,,

4.) reverse instructions to replace the new glass window..

First of all, if you have glass coverage, your new window will be installed for no charge to you; call your insurance company and check it out. That said, if you want to replace the window yourself you must remove the panel on the inside of the door to expose the window track. To do this, remove any visible screws and then use a stiff putty knife to pry up the panel. there will be clips, often plastic, holding that panel in place. If you break a clip do not worry as replacement clips are available for a few cents at any auto parts store. J.

This is not a generic problem what is the year of the truck