Question about 2001 Ford Expedition

2 Answers

If I need to replace the blower motor for my 2001 Ford Expedition air conditioner, does the entire dash have to be removed to reach it?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 447 Answers

If you are removing the main blower motor at the passenger side of the cabin then you don't have to remove the dash. It's behind the lower dash trim panel and takes about an hour and a half to two hours to do. Not to bad a job but you will need to be a bit flexible to see under there.

Posted on Jun 08, 2010

Testimonial: "Very helpful, thank you!"

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,387 Answers

SECTION 412-02: Heating and Ventilation 2001 Expedition/Navigator Workshop Manual REMOVAL AND INSTALLATION Blower Motor —Plenum Removal and Installation
All vehicles

  1. Remove the RH lower instrument panel insulator.
  1. Remove the passenger side scuff plate.
  1. Remove the passenger side kick panel.
    1. Position aside the weatherstrip.
    1. Remove the passenger side kick panel.
  1. Position back the carpet.
Vehicles with EATC
  1. Disconnect the aspirator tube and remove the screw.
  1. Remove the aspirator tube extension.
    1. Remove the screws.
    1. Remove the aspirator tube extension.
All vehicles
  1. Disconnect the electrical connector.
  1. Remove the screws and remove the blower motor.
  1. Remove the wheel from the blower motor.
    1. Remove the clip.
    1. Remove the blower wheel.
  1. To install, reverse the removal procedure.
    • Reseal the floor insulation using a suitable adhesive tape.

Posted on Jun 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn off car air conditioner blower stays on


Sounds like a relay, search the web for location on your specific vehicle. Also check the knob for function. Sometimes the knob breaks and then does not turn the shaft that controls the system.

There is also a blower motor resistor which controls blower speeds and it may melt and stay connected.

Mar 16, 2014 | 2001 Ford Expedition

1 Answer

Air Conditioning


Could be any one of several things, including a faulty blower motor, electronic controller, resistor, or relay.
Someone will need to check the blower motor for power and ground, then trace the wiring as needed.

Apr 30, 2013 | 2000 Ford Expedition

2 Answers

Ac fan speed


Replace the blower motor resister,this is the speeds for the blower motor,it is located very near the blower motor,and is mounted on the blower box,and it actually goes inside the box,to keep it cool.The reason for it`s failure is the blower motor,even though the blower motor sounds,and runs good,it is drawing too many amps.If this was at all helpful,please rate,thank you.

Jul 27, 2010 | 2001 Ford Expedition

1 Answer

No heat in my 2000 ford expedition


You should check your blend door, go to the center of your dash look down towards the floor right at the bottom on the hump (tunnel area) you will see a black or same as interior color, cover it has small slits cut in it, it is held in by two expanding type plastic bolts, they do not unscrew, just pull them out, one on each side. Once removed locate the white small box with a wiring harness connected to it, a little to the right hand side. This is the stepping motor that controls the blend door. Remove the stepping motor, and reconnect the harness, look at the motor drive unit and operate the heater control knob, does the motor turn, if it does then use a mirror and look at the drive end of the blend door itself, it is probably broken. If the door is broken, this repair just got difficult, the entire dash will have to be removed to access the environmental station, once accessed there are about 10 screws that hold the top cover on the enviromental station, undo these screws and remove the top cover, then you can remove and replace the blend door. If you are not comfortable with this difficultly level in repair I suggest you seek out your favorite local shop. removing the dash is not easy, there are alot of screws, some in very difficult places to reach. Testing the motor is easy. I hope this helps, let me know.

Jan 20, 2010 | 2000 Ford Expedition

1 Answer

2004 expedition when a turn on the AC the vents in the front don't blow any air


sounds like the front blower motor is bad on the passenger side under the dash. remove the panel under dash and you will see the blower motor housing and blower motor. check the plug in on the bottom of motor if it is plugged up and not working pull the motor out by removing the screws around motor and dropping out hook directly to battery and see if it works if it does it is a fuse or relay.

Aug 31, 2009 | 2004 Ford Expedition

2 Answers

I have a 1995 ford escort lx the air conditioner does


you either have a clogged ac line or you have a vacuum problem that will prevent the correct vent doors to open to allow the air to enter

Jul 07, 2009 | 1995 Ford Escort

1 Answer

Front air conditioner does not blow at all on any


Well, either you have a blown fuse. (Check your fuse panel)
Or
Your resistor/relay has burned out. (It will be on the passenger side under the dash and will be wired and connected between the controls and the blower motor which should look burnt if bad)
Or
Your blower motor has burned out which can be tested by applying 12 volts directly to it.

The resistor will be around $25 and the blower motor will be much more. You can get everything from a Ford Dealer or an auto parts store once you figure out what is bad.

Jun 28, 2009 | 2001 Ford Expedition

1 Answer

Air Conditioner blows hot air


I would try replacing the actual temp control switch first ( the one in the middle of the three) on the dash control unit

Jul 16, 2008 | 1999 Ford Expedition

Not finding what you are looking for?
2001 Ford Expedition Logo

919 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...