All piggybacking on a 2010 with gas engine
over a DDIS 1.9 diesel, now that dont work
Mr. ETCHU (I have the Full FSM book on this car)
NO JOB STATED, (wow !)
just nebulous ? "Marks"
you posted no year car, but most Vits have the J20a
the J20b is VVT engine, later and different.
and said timing But OF WHAT>? no job.
the left rear cam CMP sensor spark timing
or the Chain ????? try using full noun names of parts.
and win.
Ill guess chain as the CMP timing is why too long.....(have it)
the timing on all j20s is easy, twin cam 4 banger gas, and is
chain driven on all j20s
first off , the engine IS INTERFERENCE,
so dont go spinning cam or crank willly-nilly, ;and bam.
(belt off)
step 1 is set the marks aligned first before CHAIN OFF!!!!!
this engine began life here, as a J18, and books on all work j18-j20 here.
on topic.
the crank is marked for TDC
as are both sprockets.
here is the parts list view, from Suz.
http://fixkick.com/engine/20Liter/images/engine7.jpg
here is it real
http://fixkick.com/engine/20Liter/html/image_32.html
the chain is time like this.
on all J20s.
ill post the 4 steps (install ) first from FSM
Installation
Align all sprocket timing marks with timing marks on block. See Fig. 6 . Ensure key on
crankshaft sprocket is pointing up. Check that arrow on idler sprocket faces up.
1.
Install 2nd timing chain by aligning Yellow plate of timing chain with arrow on idler
sprocket. Install sprockets on intake and exhaust camshafts by aligning Dark Blue plate of
2nd timing chain.
2.
Insert a push pin into timing chain tensioner and press plunger back into tensioner body.
Ensure plunger does not come out. Install timing chain tensioner with gasket and tighten to
specification.
3.
Remove push pin from timing chain tensioner. Turn crankshaft clockwise 2 rotations then
align timing marks. Ensure all timing marks align. Apply oil to timing chains, tensioner,
sprockets, and guide. To complete installation, reverse removal procedure.
now the photo of marks
this is the FSM page, for both engines.
http://jeepdied.com/look/24hr/j18-20-chain-marks.pdf
but if the job was.
I unbolted the CMP sensor from left rear cam
that takes special scan tool , to freeze spark timing
to set it, ask. (its covered in the book, all that)
or log in to mitchell's, and READ .?
i have the full pdf on chain, if you need it.
Please can I know where the timing marks are found in Suzuki vitara engine j20
Check around the inside (towards the block) edge or crank shaft pulley by the lower passenger side of the engine. Otherwise it will be by that pulley on the bloc, those are the only laces I've known them to be. Hope it helps
617 views
Usually answered in minutes!
×