How do I replace a side view mirror for a honda accord '08? drivers side to be exact.

How To Install Replace Side View Mirror Honda CR-V 02-06 ...

? 10:31
https://www.youtube.com/watch?v=tuGFzxCVh7k
May 8, 2012 - Uploaded by 1A Auto Parts
In this video, 1A Auto shows you how to repair, install, fix, change or replace a broken, smashed, cracked, or ...

Replace 2002-2006 Honda CR-V Side Mirror, How to ...

? 14:20
https://www.youtube.com/watch?v=UKLPkZszbrA
Sep 25, 2013 - Uploaded by Go-Parts
Side Mirror purchased from www.Go-Parts.com Links to purchase products: ...

2000 Honda CR-V side mirror replacement - YouTube

posible a bad switch

Instructions1.

• 1

Remove thedoor panel. Refer to your Honda Accord repair manual for theinstructions in removing the door panel. Unhook the rods and connectors on theinside of the door panel and set it on the floor.

• 2

Remove thefilm covering the access to the side mirror. It's difficult to avoid damaging thefilm while removing it so you will need to purchase a new piece of filmcovering when you buy a new side view mirror.

• 3

Reachthrough the service hole into the mirror housing with a screwdriver. Loosen thescrew that holds the mirror. Twist the screw out with your hand.

• 4

Reacharound the door and support the mirror with your other hand. Continue to twistthe screw out, then catch the mirror as it drops out when you remove the screwcompletely. Put the screw in a safe place so you don't lose it.

• 5

Installthe new side view mirror by positioning it where the old mirror was. Insert thescrew you took out in Step 4 and twist it in with your hand. Insert ascrewdriver into the service hole to tighten the screw.

• 6

Replacethe film covering that was damaged when you took out the old mirror. Push itinto place in the indentation on the door.

• 7

Sit in thecar seat and adjust the mirror so you can use it properly.

Behind the mirror on the inside of the door there will be a triangular shape piece of plastic, gently pry the plastic from the door, now that it is removed you will see a multi electrical plug for the mirror if you have electric mirrors, seperate the plug.
look in the small holes in the door where the plastic cover was removed and you should see 2 or 3 bolt heads, remove those bolts and the mirror should now be free to remove from the vehicle

Please click on this link as you get all the instructions :

http://www.autozone.com/addVehicleId,2921501/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c15280021ad3


Good luck...

Need more info. Are you changing the mirror glass itself, or the entire driver side mirror assembly (mirror glass and plastic housing)?

auto zone pep boys napa should have aftermarket replacementsfor your mirror honda has then if money's short double stick tape and a cheap makup mirror for a temp fix

go to a junk yard as it'll be a lot cheaper there... Yes, technically you can just replace the backing and mirror. The backing is connected to the housing via two rods and some clips. The rods are (secured to the backing and these adjust the pitch of the mirror). If these rods become separated, then it may be tricky to adjust the mirror. Then again, adjust it once and it should stay