Colors of the IAT Sensor wires on a 2002 Toyota Tacoma 3.4 v6.

http://www.reliable-store.com/products/secure-download-toyota-camry-service-repair-manual-2002-2003-2004-2005-2006-download

for the easy solution download the pdf file

Intake Air Temperature (IAT) sensor and Manifold Absolute Pressure (MAP) sensor are combined into a single assembly which is called Mass Air Flow (MAF) sensor. This MAF sensor is located on the air filter box near air filter hose, and is connected with a five wire connector. You cannot replace the IAT sensor alone. Instead a MAF sensor is replaced altogether.






Thank you for visiting Fixya.

This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:

The wires going into the MAF are as follows:

White/Red = Ignition voltage

Blue/Black = E2

Black/White = E2G

Yellow/Green = THA (This is the IAT signal to the PCM)

Gray = VG

it's the sensor on the intake air duct come out of your air filter. the iat sensor is integrated with the maf sensor

it is part of the mass airflow sensor

where is IAT sensor located in toyota yaris?

firing order is 1,2,3,4,5,6

front of 1 3 5
engine 2 4 6

Front 1 3 5

of

vehicle 2 4 6

You have a distributorless ignition. This is the firing order, 1-2-3-4-5-6.
Please remember to rate this answer.