Where is the crankshaft position censor located on a 1996 dodge ram 3.9 liter v6

Here's a video on your sensor,this vehicle's engine is the same as your's. Replace Nissan 3 5L V6 Crankshaft Position Sensor

Its number two.

Tune up ,fuel filter,module,battery and connection.

Hi, suspect a fuel delivery issue. first check for fuel, then check for spark.

Please see my tip at http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Note this information, about Dodge RAM 1500 have 3.9 engine... 1996 Dodge 1500 Pickup 3.9 liter V-6 VIN "X"




This is for one 3.8L V6 1996 Dodge 3.8 liter V-6 VIN "L"




Hope helps (remember rated this).

the censor is located adjacent to the throttle control linkage, and has a 3 wire connection plug

It should be on the transmission by the passenger side of car. It has three wires connected to it.
1998 Dodge Intrepid
the crank sensor is on the passenger side of the car on the back of the engine. Check right up there by the transmission housing.
1994 Dodge Intrepid 3.3 liter

The camshaft position sensor is located under the hood in the center rear engine area, mounted on the rear center of cylinder head on the 3.0L Caravan. Hope this helped and best wishes.

The crank sensor is located on the right or passenger side of the engine, at the back on top of the transmission bell housing. It is held in with two bolts and has a single electrical plug on it. Hope this helps and good luck.

What engine ?