Cars & Trucks Logo

Related Topics:

Posted on May 29, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Tail light cover removal? How do you remove the covers for the tail lights?

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Expert 270 Answers
  • Posted on May 29, 2010
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Jan 24, 2010
Answers
270
Questions
1
Helped
122656
Points
867

HI: To remove the Lens for your Rear Lights ,Just remove them from inside your Trunk: You'll Proball Beable to See The Hold Down Studs and Nuts Holding them In Place By Removing some of your Trunks Interior Linings In and Around Where your Tail Lights Are Mounted.Just Remove only the Interior Panels To Expose Your Access To Removing Your Tail Light Lens/Or Covers. Hope This Helps you Let Me Know By Voting For me. Thanks the WYOCWBOY

5 Related Answers

Anonymous

  • 458 Answers
  • Posted on Jul 18, 2008

SOURCE: 2000 Ford 150 Truck

Unscrew the light covers and you will see the bulb.

Ad

Anonymous

  • 45 Answers
  • Posted on Nov 13, 2008

SOURCE: remove passenger tail light

I have not yet worked on a Pilot, but from experiance, a lot of tail lights are pulled from the inside and not the out. You may check to see if it comes out from the trunk and not straight off the back from the outside.

gabenevins, a lot of places are selling the entire assembly and not just the lens. I would continue looking until you find just the lens unless you want to buy the whole piece. I do not know what the cost difference is. Perhaps pjpc might be able to tell you where to get just the lens.

Anonymous

  • 448 Answers
  • Posted on Oct 23, 2009

SOURCE: The interior dome light is burned out, removing cover problem.

You will have to pry off the lens CAREFULLY using a small screwdriver. There are two little plastic protrusions on each long side of the lens which fit into the casement. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.

Anonymous

  • 28 Answers
  • Posted on Feb 08, 2010

SOURCE: How do remove the rear lens cover on the tail

The lens covers dont come off. You can access the bulb from inside the trunk. By opening the panels

Anonymous

  • 1 Answer
  • Posted on Feb 21, 2010

SOURCE: how to replace rear turn signal light bulb

I just changed my rear turn signal. Really easy. There is two 1/4 inch bolts visible when you open the tailgate. Take both of those out and gently lift the light housing out towards the outside of the vehicle. There is two small clamps on the other side of the fixture that just slide right out when you pull on it. There you go

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do you remove the tail light lens cover for a 1987 Nissan Pickup truck

You can't remove the lens cover. The tail lights are molded as one piece. If you want to change the bulbs, there should be an access panel inside the truck box right behind the tail lights that gives you access to the bulbs. There are also screws to remove the entire tail light assembly if it needs replacing.
0helpful
1answer

How to change a light bulb of a tail light

Remove the tail light cover from inside the van, pop the cover first, then remove the socket by turning it left about hlaf a turn, it will pop out, remove the burned bulb, replace with new one of same type, assemble back reverse of removal.

Good luck.
0helpful
1answer

How to change a tail light

1. Remove the two screws at the outside back of the tail light cover
2. loosen the tail light cover from the two clips at the front of the cover by gently prying it toward the rear. Fingernails worked for me. The bottom clip seemed easier. If it is too tight, try a screwdriver near the bottom, then near the top prying toward the rear of the car.
3. the top light is the backup lamp (white), and the bottom light is the brake/turn/rear light (red).
4. rotate the lamp 1/3 turn to remove and replace.
5. test.
6. replace the cover by aligning the screw holes then pushing the cover into the clips and replacing the screws.
0helpful
1answer

2001 Ram 1500 Truck 2WD: how do you remove a tail light from a 2002 dodge r...

There are for Philip screws holding your tail light cover onto your dodge. Step 1: Just remove those screws and pull the cover off. Step 2: Remove the light bracket out of the cover and replace with a 1057 bulb.
1helpful
1answer

How do I replace my tail light bulbs on 1990 LeSabre? How do I get into the assembly to get to the bulb?

OPEN TRUNK LOOK WHERE TAILS LOCATED LOOK FOR LARGE PLASTIC WING NUTS.REMOVE THEM PULL TRUNK LINER AWAY ENOUGH TO REMOVE THE OTHER PLASTIC WING NUTS HOLD THE TAIL LIGHT COVER.WHEN YOU REMOVE ALL THE PLASTIC WING NUTS THE TAIL LIGHT COVER WILL COME OUT ENOUGH FOR YOU TO REMOVE THE BULB.
0helpful
1answer

Changing tail lights?

open trunk if lights on trunk you have a opening you can see the light electrical connector .if lights on lower part of trunk.remove large plastic screws. pull back trunk lining .you will see some more long plastic wing nut screws.remove them and the light cover come out then you replace light bulbs.
0helpful
1answer

Tail light assembly

If you look inside the trunk, you will need to undo the panel inside trunk to gain access to the bolts that mount the tail light assy's.
2helpful
2answers

How to replace tail light

First you need to lift the hatch. There are two screws under plastic caps. Remove the caps and you will be able to unscrew these screws. Carefully using a flat screw driver to pry out the tail light assembly. It have to plastic pin that attached to the car body. do not break the pin. After you pry out the tail light assembly, you will be able to replace the light bulb. Replace everything in a reverse order.
Not finding what you are looking for?

919 views

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...