Hello,
I need to know how to removal the ignition cylinder from my 1997 toyota camry. I have my steering column off I have this thing torn apart but I am reading on a 1998 all i have to do is disconnect some wires that are attached to it? How do I do this. My hand can't fit in there?
There are a number of videos available detailing this procedure. Try this Replacing 1997 Toyota Camry Ignition Lock Cylinder
SOURCE: How to remove ignition cylinder from Toyota Camry 1993
Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!
CAUTIONSome
models covered by this guidemay be equipped with a Supplemental
Restraint System (SRS), which uses an air bag. Whenever working near
any of the SRS components, such as the impact sensors, the air bag
module, steering column and instrument panel, disable the SRS, as
described in .
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
To install:
SOURCE: power steering rack 1998 toyota camry
replacing a steering rack is never easy unless you have done it multiple times and will always be diff. from any vehicle
SOURCE: power steering belt on 1991 toyota camry
Locate the idler pulley. Loosen the nut in the center of the idler pulley. Then loosen the bolt that protrudes from the back of the pulley. This will let the belt go slack.
SOURCE: REMOVING STARTER ON 1994 TOYOTA CAMRY LE
The starter is found under front end.. Near where the moter meets the trani - you will see the flywheel (a big round gear) the starter connects to the flywheel to turn the motor..
Disconnect the battery..
Disconnect wires from starter..
Should be 2 bolts that hold the starter in - remove them..
The starter goes in only one way so you cant mess it up..
Rate well ;o)
SOURCE: ignition lock cylinder removal without key
take the pannelling off around steering wheel inset a screw driver in key slot brekaway barrel to release steering lock pin then at other end of barrel take out scre and pull on wiring harness to expose a plastic barrel that will allow you to start car with a screw driver ect and you would not have steering lock as pin has been removed
660 views
Usually answered in minutes!
×