Re: Automatic hyundai lantra 1998 over drive button not...
My 2000 elantra (2.0) had same prob., got a throttle position sensor (side of throttle body) from junk yard and fixed the prob. But yours could be diff. cuz it's a 98
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hyundai Elantra transmission won t go into reverse m ...
www.fixya.com > ... > Cars & Trucks > Hyundai
Hyundai Elantra cars & trucks transmission won t go into reverse m ... Question about 1998 Elantra. 1 Answer · Reverse gear almost dead in 1998 Lantra auto.
\'93 Hyundai Lantra, automatic transmission has trouble changing up from 1st to 2nd, it tends to rev on a bit, clunks once or twice before changing to 2nd, other gears seem to be ok. Oil levels are ok and have recently replaced the transmission oil (yes the correct oil was used)
try the left side of the engine... gear oils smell are diffent from the engine oil and the viscosity... gear oils are thicker... u wont go wrong on this...
The timing belt is normally replaced at 100,000 km (approx. 60,000 mi), but must be checked for wear and tear starting 75,000 km(approx. 45,000 mi) along with a major tune-up.
The switch near the shifter is the ECT (transmission control) which selects NORMal driving mode, and PoWeR mode. It is the battle between economy (NORM) and driving performance (PWR). As tested, the PWR mode delays your A/T upshift to a higher RPM. This utilizes your engine's higher revs, but really cuts into fuel economy.
go slow in the car about 15 to 20mph then put the car in fourth gear and accelerate if the car bogs down then the clutch is good if the car revs up then the clutch is slipping.
You have a bad O-ring seal in the valve body of your transmission. The reason you barely move when you rev high, is because the trans fluid isnt going to the correct part of the valve body due to the bad seal. This should be a repair you can do yourself if you have any mechanical experience, OR a transmission shop may be able to rebuild the valve body for you.
I've got Hyundai Lantra 1.6 year 2000. It's take time to start when it's hot. When I start my car it revs at about 2k-3k rpm. It also does it when I come to a stop. When I come to a stop it will stay at a higher rpm than that of idle speed. It drives ok when on freeway but uses more petrol. I have changed the water & petrol pump but no luck
×