Hi. Please see procedure below:
Determine which alternator your Toyota Tundra will need. You'll want to be sure the new alternator is compatible with your Tundra's engine. Models built from 2000 to 2004 have a 3.4 L or 4.7 L engine. Models made from 2005 to 2006 offer options for a 4.0 L or 4.7 L engine. Starting in 2007, the Tundra is available with 4.0 L, 4.7 L and 5.7 L engines.
Disconnect the negative battery cable with a socket wrench. Remove the gravel shield if you need to access the alternator from under the car. Remove the electrical connector and unfasten the retaining nut on the alternator terminal with a socket wrench. This will allow you to remove the battery terminal wire.
Unfasten the lock nut, pivot bolt and adjusting bolt on the alternator with a socket wrench. Remove the drive belt and take the alternator off the vehicle.
Install the new alternator assembly. Use a torque wrench to tighten the lock nut to 25 ft. lbs. and the pivot bolt to 38 ft. lbs. Attach the adjusting bolt.
Connect the electrical harness and battery terminal wire to the alternator and fasten the retaining nut to the alternator terminal with a socket wrench. Install the gravel shield if you removed it. Replace the drive belt and restore it to the proper tension. Reconnect the negative battery cable with a socket wrench.
Thanks!
I replaced the new alternator but I have new problem that when I started the engine, there are ABS, Airbarg, Brake and tracking light lid up or blinking. Evrything seems shut down, no power window, no power lock or stereo. Is that mean the computer shut down or shorted when I change the new alternator? Please adivse if it's a computer problem? How can reset it back to the normal condition. I couln't not change the gear to drive. It is also locked at this time. Thank you.
×
SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights
check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me
SOURCE: Where is the 2007 toyota tundra transmission dipstick
if its a manual transmission you will have a plug on the side of the trany you take the top plug out to check the fluid
SOURCE: How to change transmission oil and finding the dip
There is no dipstick the fluid level is checked by warming the trans fluid up to a certain temp. and removing the overflow plug on bottom of pan. Fluid is filled through fill plug on side of trans.
SOURCE: how do you replace the serpentine belt on a
one of the idler pulleys is spring loaded ,look carefully to see what one it is then look to see if it has a square drive to put a rachet bar in to release the tension.
SOURCE: Serpentine Belt routing diagram for 2007 Toyota
Installing fanbelt on 2007 Toyota Tundra 5.7
4,589 views
Usually answered in minutes!
schematic alternator tundra 2007
×