Edelbrock 1406 3 years old on a Chevy 350 corvette. Starts and runs great when cold but when it heats up to running temp. and I shut off the engine it will not start!! Has great spark,compression,and fuel. Please Help!

have the tps checked possible dirty or bad connection in the sweep it's sealed so can't be cleaned.

You need a subscription to the car magazines & follow
that stuff

Call Edelbrock, I'm sure they have tech people to help you

Take to dealer and use your warranty.

fuel pump

tdc is usually set at 8 degrees BTDC for an automatic and 4 BTDC for a manual transmission. This may help. Does the engine run rough at start up being set at 0TDC?

Replace the ignition module.

there must be something restricting the water flow. i would check the houses to make sure there are no sharp turns that dont need to be there. next i would upgrade the water pump to make up for the extra hp.
flushing the block is always a good idea too when adding hp because you never know whats inthere.

Yep that is what the code is for. Make sure the passage is clean after you pull it off.

I think you are onto something. The thermostat in my opinion is too low causing the radiator to not cool enough before it is sent back into the motor. The block and the pistons are heating up causing it to run poorly. When was the last time you had your radiator flushed? ( I would have said that the headers are heating up the starter and this is causing the drain on the battery but you stated that once you get the car started it runs rough so i would have to rule the starter out.)

If it is a 4 barrel you need to run a higher octane than a 2 barrel. You need to check your timing and readjust your mixture and air flow.