I have a 2001 Lincoln LS that needs an engine. Wh...

Hi Danny,I have a 2004 Lincoln LS, 3.0 haven't had that problem so far,have 125.000 miles on it.Here's a video I found on your sensor,a lot of things are put on our engines that are hard to get to,like the spark plugs. Lincoln ls 2001 V6 3 0 temperature sensors YouTube

Yes both years used that engine.

http://www.ehow.com/how_6353103_reset-light-2000-lincoln-ls.html

follow the instructions carefully, if this does not work, you may need to call the dealer to see if they have any other procedures, good luck!

The engine should be separated from the trans at least 1 "and the torqu convert slid into the trans. There may be a dowel pin on each side. That is wh the one inc.

called the dealership? thanks

its not a easy job, but you need to get the gasket so it wont leak, theirs some tutorials online, if you dont want them to burn out, dont put the covers back on when you change them, it creates a suction and heat which makes oil spill and burn the coils

replace the intake gasket.

303-07A: Engine Ignition — 3.0L (4V) 2001 Lincoln LS Workshop Manual DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil-on-plug (COP) ignition system.
---------------------------------------------------------------------------------------
SECTION 303-07B: Engine Ignition — 3.9L 2001 Lincoln LS Workshop Manual
DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil-on-plug (COP) ignition system
-----------------------------------------------------------------------------
v-8
SECTION 303-07B: Engine Ignition — 3.9L 2001 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Ignition Coil Removal

1. Remove the air cleaner outlet tube. For additional information, refer to Section 303-12 .

1. Remove the bolts and the ignition coil cover.

1. Disconnect the electrical connector from each ignition coil.

1. Remove the ignition coils.
   1. Remove the bolts.
   1. Remove the ignition coils.

------------------------------------------------
v-6

SECTION 303-07A: Engine Ignition — 3.0L (4V) 2001 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Ignition Coil Removal

1. Remove the engine appearance cover.

1. To access the RH bank ignition coils, remove the upper intake manifold. For additional information, refer to Section 303-01A .

1. Disconnect the electrical connector from the ignition coils.

1. Remove the bolts.

1. Remove the ignition coils.

please rate as fixed if this helps.

It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.

2002 linclon ls 3.0 v6 pcv location