Put new battery into Jeep Wrangler, vehichle will still not start. Power comes to vehichle when ignition is turned on. Wont start if atempted to jumped but poping the clutch will start the Jeep.
SOURCE: 95 Jeep Wrangler wont start
Well two things are happening here... the people saying fuel regulator, you guys are not having the same problem. the relay buzzing is the indicator that the computer is bad. The relays that are buzzing get engergized by the computer. Notice the Check Engine Light won;t come on until after the buzzing is over. Now the fuel problem is different from that becuse the computer is working fine but the pump can't build enough pressure in the first second (like it is suppose to do) during the priming before you turn the key to start. Sorry for all you with the computer problem ain't cheap...
Take it to the Jeep dealer . It's still under warranty. Won't cost you a penny. Good luck.
SOURCE: 91 Jeep wrangler New everything idles rough, no Power then dies
you check for miss how is compression
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Testimonial: "Will try! Thanks!"
SOURCE: 2004 jeep wrangler unlimited wont start ,4.0l auto
Nuetral safty switch, Starter solenoid.
Do you have antitheft?
The ground for the starter relay may be computer controlled. Lee
192 views
Usually answered in minutes!
×