Location diagram of various component’s serial numbers
SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe
If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.
Hope this is of some help.
Ed
SOURCE: 2001 Hyundai Santa Fe Error codes BB1,BB2,BB3,
EVAP system is a very COMPLEX system. There is not enough time or space here to adequately diagnose your problem. Components involved are Canister Close Valve, Charcoal Canister, Canister Filter, Purge Contro Solenoid Valve, Fuel Tank Pressure Sensor, EVAP tubes & hoses, Fuel Pump Gasket, fuel tank itself, check valves, Electrical Wiring to and from the ECM and components. Best solution: Pay diagnistic fee and have professionals diagnose problem. This way you'll know EXACTLY what the problem is and what's required to fix it (parts, labor, tax, time-frame, etc.).
SOURCE: 2001 Santa Fe: replacing an alternator
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
SOURCE: where is the trans speed shaft sensor on a 2001 hyundia santa fe?
There are two speed sensors, Input sensor is located on top of the bell house. Output sensor is located on the firewall side of the bell house.
SOURCE: where is the pcm located on a 2002 hyundai santa
Hello
The PCM( ECU) is located on the floor center hump, below dash. To excess, remove kick panel to the right of gas pedal.
Steve
4,763 views
Usually answered in minutes!
×