SOURCE: C70 Manuel On Line
Scroll down a bit
http://www.devicemanuals.com/guide/Automobile/Volvo/1999-Volvo-C70-Owner%27s-Manual-==TVRBM05UWTU=.html
please rate if this helps Thanx
SOURCE: need radio code for 1999 volvo v40
you will need to call volvo dealer with your vin number and they will give you the code for that vin# and car
SOURCE: I need the radio Code for my VOLVO S40 1999 2.000 cc
Hello,
I found three solutions somewhere, hope one works for you!
Good luck! Just tell me which worked.
I am wish to import a S40 too, can you give me the exporter's name and site?
Rigo
#1
. It went like this, turn radio on, when “code” is displayed push and hold “6” while pushing “power & volume” knobs at the same time. Let radio turn off while continuing to hold “6”. Turn radio back on by pushing both “power & volume” knobs at the same time. It worked on 98 V90.
#2 (JAPAN IMPORT)
-I emailed 2 Volvo Dealers and both replied 6666 is the code for all used Volvo imports from Japan, so I switched the ignition key to pos I for over 2.5 hours and "CODE" appeared, then pushed button 6 four times and the Radio swiched On. Problem solved.
#3
-we altered the client access code input protocol by “rebooting” the stereo (turning it off and on using the combined volume/power input) and, at the same time, holding down the “stereo preset 6” button. The stereo then transitioned into the authenticated mode, allowing clients to listen to NPR without proving identity.
SOURCE: 1999 volvo radio code
To reset the radio you have to leave the key in position one (the radio will come on, but the dash lights are not on) with the radio on for at least two hours. It can take up to four hours to reset.
Make sure the climate control and blower are in the off position to keep the battery from running down. Eventually the radio will say "code". There is a four digit code that is unique to each radio, if you don't have it you must contact the local Volvo dealer and have your VIN code. The VIN code is locate on the far top/right side of the dash, you must be outside the car to see it. It will begin with something like YV1LS...................
When you get this code from the dealer you input the code using the radio preset (1-6 buttons). If the radio says code again that means it is the incorrect radio code. Most likely the radio has been replaced. Then it would be alot easier to take it to the dealer since the radio has to be removed and the serial number taken off the radio chassis unit. Usually most dealers will do it for free if they think you'll come back for services, so just tell them you just bought it and be nice, hopefully it will work.
hope this helps
SOURCE: I have fault code p1171 on my 1999 volvo C70
90% of the Time..Code 1171 is an 02 sensor. Other 5% Is a Mass Airflow Sensor.. And Last .. Fuel Pump.. If engine seems to run fine.. its an O2 sensor.. Thank you
453 views
Usually answered in minutes!
×