It depends on why it is stuck,. There is a cable in the door that raises and lowers the window. IF the cable is misfed on the roller or it is jammed on a pulley then you cannot move the window at all by pulling on it. If the cable is broken or has slack then you could raise it but it will fall back down.
SOURCE: how to change out power
you can open the inside cover of the door and you can find the power window motor inside.
good luck
drcool
SOURCE: How to change Dodge Stratus door.
use two people cause the doors are pretty heavy and when you take ou the bolts one person will need to hold the door up
SOURCE: 2003 dodge stratus rpm wont rev past 2.5 on an
This sounds like a vcuum leak in one of the hoses and you can check this by getting a can of carburetor cleaner and spraying short squirts around the enging area. It the idle jumps up when spraying the try to locate why and where your sprayed. See if you can here a hissing like sucking air. Next step and you might as well check it any how is the aiir filter. Take it out and hold it to the sun or some bright light and see if the light is trying to filter through. If not and it is dark then knock it gently on something and try to get most of the dust and dirt off it. This may give it a quick fix but will need to be replaced pronto. If neither of these tips help then let me know and I will come up with some more test for you. Good Luck, Raz
Testimonial: "thanks let ya know. later."
SOURCE: have to replace the passanger side mirror on 2000
remove the triangle trim piece on the interior side of door (usually snap on a delicate pry with a flat head screw driver will do the trick)
next remove the (3) 10mm nuts securing the mirror to the door, next unplug the mirror by squeezing the plug connector, pull the mirror of the outside of vehicle. Reverse this order during installation and you should be fine.
Note the mirror may fall and scrath the paint while the nuts are off, keep a hand on the old mirror to prevent from falling during removal
SOURCE: I HAVE A 2004 DODGE
remove the switch and check for continuity in the switch. If good then check the motor the same way. If either one shows numbers that do not hold steady replace them. it should hold steady numbers when read. if the display shows O L it means it is an open circuit which is faulty
For all types of power window problem and power windows not
working,i suggest you to go through the help links given below. Click the link
to go through its procedure to troubleshoot the problem :------
Power window problem
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------
Power windows not working after car wash?http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html
---------
power locks, power window and power mirror not working?
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html
------------
All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html
-------------
Complete Diagnosis & Testing Power Windows?
http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html
-----------This will help.Thanks
186 views
Usually answered in minutes!
×