Traction control and ABS lights stay on - 1996 Oldsmobile Aurora

Today, most new vehicles come with either an ABS or a traction control system. A problem in the ABS or traction control system is usually indicated by a warning light. When the ABS warning light is on, it means that the ABS has been shut down because of a mechanical or electrical failure.

First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

The light being on means the system has detected a problem in one or more sensors. The vibration is the ABS modulating the brakes to prevent skidding because it has detected a wheel that is locked up. That wheel is most likely the one sensor that is giving you the error.

It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

For this VCS and traction lights coming ON,its advisable to check/click this help links :----
VCS maintenance required ? http://howtobyme.blogspot.com/2011/11/vcs-maintaince-required-on-toyota-camry.html------- VCS and ABS lights go on and off intermittently? http://howtobyme.blogspot.com/2011/11/vcs-and-abs-lights-go-on-and-off.html
--------Traction control message? http://schematicsdiagram.blogspot.com/2012/01/traction-control-message.html
---------The ABS and Traction Control Lights stays ON dash of car? http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
----------This will help.Thanks.

I have a 2001 Cadillac Deville with 105,000 miles. The ABS and Traction Control light stay on. What could be the problem? Could I reset the ABS and Traction Control light?

If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.

had my 2000 chev impala 3.8 liter ,traction control llight and abs light both go on the reset it and go right back on .so i replaced both sides of the bearing hub assembly this is connected the senser,so far so good.replaced it dec 21 2009 about 3 hours ago. because the assembly came appart when took off.

Sounds like you have a problem in the front brakes or a front wheel speed sensor. A common cause for a Traction light is a faulty front ABS wheel speed sensor or harness. When the Anti lock brake computer sees a problem in the ABS syetm, it disables traction control as well.

The traction control system is controlled through the Anti-lock brake system. The way it works is if one of your wheels starts spinning the ABS applys the brake to that wheel to transfer power to the oppsite wheel that is getting traction. If your ABS is bad then your Traction control won't work. To check it I would find a parking lot on a wet day. In an open space mash in the gas. if you hear the ABS system kick in and you don't squall the tires then your good. My guess is you won't. What I would be worried about is will my ABS work. When checking the traction control is a good time to check the ABS. Acclerate to around 15 mph, then mash the brake as your live depended on it. If you hear a motor run and feel a vibration or grind in the brake peddal, then it works.