How to change rear tail light on 2006 honda odyssey

I would read 'Back Up' as reversing lights and camera if equipped.

Fuse Box Diagram Honda Odyssey (RL3/RL4; 2005-2010)

https://fuse-box.info > honda > honda-odyssey-rl3-rl4-...

The interior fuse boxes are located under the dashboard on the driver's and passenger's side. The location of the fuses in the passenger compartment: Honda ...

Honda Odyssey (2006 - 2007) - fuse box diagram

https://www.autogenius.info > honda-odyssey-2006-20...

May 14, 2017 - Primary engine compartment fuse box ; 1, 10, Left Headlight Low ; 2, 30, Rear Defroster Coil ; 3, 10, Left Headlight High ; 4, 15, Small Lights.

https://www.google.com/search?q=2006+honda+odyssey+fuse+15

..

see if u have voltage at the socket. Try a working bulb, If not ck the wiring for a break. usually at the trunk hindge is a popular electrical short location.

WOW!
http://m.carcomplaints.com/Honda/Odyssey/2006/body_paint/structure-body-door_.shtml

Possible recall: 2006 Honda Odyssey Structure Body Door Problems

inside the rear cargo are are 2 pop out access flaps, remove them and peer inside. The Tail light guts are visible. Bolts to remove the entire assembly, or get some small hands to twist out the offending bulb sockets. Careful, body acces hoes have sharp edges.

Your license plates work on the same curcit as your tail lights so therefore have the same fuse, if you tail lights are working and your plate lights not it isn't the fuse. check the globe and contacts where the globe and globe holder fits.

A bit of penetrating oil often does the trick.

dealer is and ***, there will be a fuse somewhere for that area, what else does not work, normally each sidelight is a separate curcuit, front and rear on each side on same curcuit, hence would guess bad earth curcuit in the unit. email honda and report dealer and ask same

YOU MUST REMOVE THE INSIDE PANEL TO GET TO THE LIGHTS

make sure u have put the right bulbs in. rear brake lamps are dual filament....

Yes, there is a "spear point" plastic clip that is still engaged into a socket type holder in the front outboard portion of the tail lamp assembly. Pry gently with a tape wrapped screwdriver at the front outboard corner of the assembly and the clip will release. You will then be able to see how the clip works and will be able to align and engage it first when replacing the tail lamp assembly.

-T

open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).