300M, Concorde, Intrepid, LHS, 1998-2004 - Fuel Filter Removal & Installation
The fuel filter mounts to the frame rail in front of the fuel
tank. The inlet and outlet ends of the filter are marked for
installation purposes. Install the fuel filter making certain that it is
properly orientated.
NOTE
The fuel filter is part of the fuel pressure regulator mounted on
the fuel pump module.
To install:
Negative battery cable
Purge and vent lines
Fuel line from the pressure regulator
Filter/regulator by pushing in the locking tab, turning the
regulator to unlock it and pulling the it straight up
Fig. Cut away view of the fuel filter/pressure regulator
Fuel Pump - Removal & Installation
The
in-tank fuel pump module contains the fuel pump and pressure regulator
which adjusts fuel system pressure. Fuel pump voltage is supplied
through the fuel pump relay.
The fuel pump is serviced as part of
the fuel pump module. The fuel pump module is installed in the top of
the fuel tank and contains the electric fuel pump, fuel pump reservoir,
inlet strainer fuel gauge sending unit, fuel supply and return line
connections and the pressure regulator. The inlet strainer, fuel
pressure regulator and level sensor are the only serviceable items. If
the fuel pump requires service, replace the fuel pump module.
To install:
Negative battery cable
Fuel tank
Fuel lines from the fuel pump module by squeezing the
quick-connect fitting with thumb and forefinger
Fig. Using special tool 6856, remove the fuel pump module locknut
Fuel pump module electrical connector from the top of the fuel
pump module
CAUTION
The fuel reservoir of the fuel pump module does not empty out when
the tank is drained. The fuel in the reservoir may spill out when the
module is removed.
Hope this helped.
Fuel tank
Fuel pump module electrical connector
Negative battery cable
1,747 views
Usually answered in minutes!
×