STARTER REPLACEMENT ( 1995-97 4.3L MODELS )
Fig.: The starter motor on later model 4.3L engines is retained
by two long bolts
To install:
Hope this help (remember rated this help) Good luck.
Disconnect the batteries ground cable
disconnect the solenoid wire and the battery cable from the starter
remove the two thru bolts from the starter drives housing that thread into the engine block
wiggle the starter out taking note if any shims were in place
reverse this proceedure to install
SOURCE: Starter in a 1992 GMC Sonoma 4.3 v6
bottom rear of engine on the passenger side, the starter is serviced from under the car. it is held to the engine block with two bolts, then u must remove the battery cable and starter solenoid wiring as well, always disconnect the battery before doing any work on the starter.
SOURCE: 1999 GMC sonoma starte installation
2.2L Engine remove protective shields as needed then remove front exhaust pipe. Remove the brace from the engine to the clutch housing, then disconnect starter wiring. 4.3L Engine 2 wheel drive just remove the right front tire and you will have access to the wiring. 4.3L Engine 4 wheel drive you must remove the differential carrier shield if equipped then remove the starter bolts and rotate the starter to get access to the wiring. Good Luck.
SOURCE: how do you change starter on 95 gmc sonoma?
4 cyl or 6> 4 cyl must remove the exhaust at manifold then the bar from engine to tranny then starter it is a tight squeeze
SOURCE: HOW TO CHANGE DRIVE BELT ON MY 98 GMC SONOMA 4
it may be easier to attach the breaker bar to the tensioner arm from under the vehicle to relieve belt tension
To install:
SOURCE: how do I install starter for 2000 GMC Sonoma
the starter will be located on the lower right side of the engine and it is located near some key components for your vehicles ignition system. If you do not consider yourself at least a "B" level technician, I would suggest that you take it to a nearby shop in which u trust.
3,578 views
Usually answered in minutes!
×