Locked radio changed broken radio for used one it is locked

dealer with vin or vehicle and proof of ownership

sure, the CHevy FSM has all this, the
chevy factory service manual.. ever seen one,?
if no time to buyone used, (ebay has em)
then login to alldata.com
they have the schematics there.

nothing on dash is blown fuse,
nothing means to me the CEL/SES lamp is out and if out key on
that means the PCM is dead but it started so is not dead.
the lamps all glow key on (cluster) to tell you the self tests all pass.
basics,......
door locks
windows
and radio
fuses. first. for ever and ever . fuses first.
check the fuses.
test them , some that look good are in fact bad.
need a video?

change the ignition key lock, remove trim panel around radio and ignition switch. now take out the 2 screws that hold switch in. then disconnect it. the trim around radio just pulls out. be carefull not to break it.

How to Reset GM Theft lock Radio's

Article Disclaimer: This article is meant to be used by Delco Radio owners to reset there radios. In no way is it meant to be used for any unethical or unlawful ways.

Purpose

The following instructions will allow you to reset any GM (General Motors), Cadillac, Oldsmobile, Buick, Pontiac theft lock radio.

Requirements

The theft lock radio must be in "LOC" mode.

Procedure:

1. Turn the ignition ON (The radio should display "LOC")

2. Hold down the Radio Presets 2 and 3 buttons for six seconds

3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step.

4. Press the AM/FM button

5. The radio display changes to another three-digit number. Write this number to the right of the first one.

6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05

7. Call 1-800-537-5140

8. Press 1 then # (pound). You'll hear "Invalid Code, try again"

9. Press 139010 or 106010 or 206010 or 202107 then # (pound). "it's really *<star>lol"
You will be asked to enter your four or six digit code followed by *

10. Enter the number from STEP 6 then *

11. Listen to the four-digit number and write it down. It will be repeated twice

12. Turn the ignition ON (The radio displays LOC)

13. Use the MN and HR buttons to enter the code from STEP 11

14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable.

Dealership Codes

* 139010
* 106010
* 206010
* 202107

Troubleshooting

If you fail to enter the correct code eight times, the radio goes into INOP mode. You have to wait an hour with the ignition on before the radio returns to LOC mode.

Thank you for using fixya and good luck

You have to go to a chevy dealership to have them unlock the radio. They use a special code that will unlock the radio and then allows you to pick a new code. Hope this helps.

How to Reset GM Theft lock Radio's

Article Disclaimer: This article is meant to be used by Delco Radio owners to reset there radios. In no way is it meant to be used for any unethical or unlawful ways.

Purpose

The following instructions will allow you to reset any GM (General Motors), Cadillac, Oldsmobile, Buick, Pontiac theft lock radio.

Requirements

The theft lock radio must be in "LOC" mode.

Procedure:

1. Turn the ignition ON (The radio should display "LOC")

2. Hold down the Radio Presets 2 and 3 buttons for six seconds

3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step.

4. Press the AM/FM button

5. The radio display changes to another three-digit number. Write this number to the right of the first one.

6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05

7. Call 1-800-537-5140

8. Press 1 then # (pound). You'll hear "Invalid Code, try again"

9. Press 139010 or 106010 or 206010 or 202107 then # (pound). "it's really *<star>lol"
You will be asked to enter your four or six digit code followed by *

10. Enter the number from STEP 6 then *

11. Listen to the four-digit number and write it down. It will be repeated twice

12. Turn the ignition ON (The radio displays LOC)

13. Use the MN and HR buttons to enter the code from STEP 11

14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable.

Dealership Codes

* 139010
* 106010
* 206010
* 202107

Troubleshooting

If you fail to enter the correct code eight times, the radio goes into INOP mode. You have to wait an hour with the ignition on before the radio returns to LOC mode.

check all your fuses,,,sometime the radio display is on a separate fuse.....

sometimes the radio has a seperate small wire that goes to the battery it probably is disconnected also check the wiring that goes from the radio to the battery you may have disconnected or accidently broken a wire

i'm not familar with that particular radio.... but try unhooking the battery for about ten minutes then hook the battery up again.... it should be fine.


Robert

you need to have a new key fob programed to de immobillize the vehicle there is not really a way round this with out big wiring changes